[PATCH 1/3 v2] Input: atmel_mxt_ts - Fix up inverted RESET handler

[Dmitry Torokhov]

On Wed, Nov 04, 2020 at 04:30:30PM +0100, Linus Walleij wrote:
> This driver uses GPIO descriptors to drive the touchscreen
> RESET line. In the existing device trees this has in
> conflict with intution been flagged as GPIO_ACTIVE_HIGH
> and the driver then applies the reverse action by
> driving the line low (setting to 0) to enter
> reset state and driving the line high (setting to 1) to
> get out of reset state.
> 
> The correct way to handle active low GPIO lines is to
> provide the GPIO_ACTIVE_LOW in the device tree (thus
> properly describing the hardware) and letting the GPIO
> framework invert the assertion (driving high) to a low
> level and vice versa.
> 
> This is considered a bug since the device trees are
> incorrectly mis-specifying the line as active high.
> 
> Fix the driver and all device trees specifying a reset
> line.
> 
> Cc: Krzysztof Kozlowski <krzk at kernel.org>
> Cc: linux-arm-kernel at lists.infradead.org
> Cc: linux-tegra at vger.kernel.org
> Cc: linux-samsung-soc at vger.kernel.org
> Cc: NXP Linux Team <linux-imx at nxp.com>
> Cc: Pengutronix Kernel Team <kernel at pengutronix.de>
> Signed-off-by: Linus Walleij <linus.walleij at linaro.org>

Applied, thank you.

-- 
Dmitry