[PATCH 3/3] ARM: dts: sun8i: s3: switch PineCube to use OHCI/EHCI only

[Icenowy Zheng]

The PineCube board features a USB Type-A connector connected to the
SoC's USB pins.

As this is not designed for being used as a USB device, disable OTG
controller and route USB to OHCI/EHCI fixedly.

Signed-off-by: Icenowy Zheng <icenowy at aosc.io>
---
 arch/arm/boot/dts/sun8i-s3-pinecube.dts | 17 ++++++++++++-----
 1 file changed, 12 insertions(+), 5 deletions(-)

diff --git a/arch/arm/boot/dts/sun8i-s3-pinecube.dts b/arch/arm/boot/dts/sun8i-s3-pinecube.dts
index 4aa0ee897a0a..c4177c54ef29 100644
--- a/arch/arm/boot/dts/sun8i-s3-pinecube.dts
+++ b/arch/arm/boot/dts/sun8i-s3-pinecube.dts
@@ -78,6 +78,12 @@ csi1_ep: endpoint {
 	};
 };
 
+&ehci0 {
+	phys = <&usbphy 0>;
+	phy-names = "usb";
+	status = "okay";
+};
+
 &emac {
 	phy-handle = <&int_mii_phy>;
 	phy-mode = "mii";
@@ -158,6 +164,12 @@ &mmc1 {
 	status = "okay";
 };
 
+&ohci0 {
+	phys = <&usbphy 0>;
+	phy-names = "usb";
+	status = "okay";
+};
+
 &pio {
 	vcc-pd-supply = <&reg_dcdc3>;
 	vcc-pe-supply = <&reg_ldo3>;
@@ -224,11 +236,6 @@ &uart2 {
 	status = "okay";
 };
 
-&usb_otg {
-	dr_mode = "host";
-	status = "okay";
-};
-
 &usbphy {
 	usb0_vbus-supply = <&reg_vcc5v0>;
 	status = "okay";
-- 
2.28.0