[PATCH v2 2/2] arm64: dts: ti: k3-j7200-common-proc-board: Correct the name of io expander on main_i2c1

[Peter Ujfalusi]

J7200 main_i2c1 is connected to the i2c bus on the CPB marked as main_i2c3

The i2c1 devices on the CPB are _not_ connected to the SoC, they are not
usable with the J7200 SOM.

Correct the expander name from exp4 to exp3 and at the same time add the
line names as well.

Signed-off-by: Peter Ujfalusi <peter.ujfalusi at ti.com>
Reviewed-by: Vignesh Raghavendra <vigneshr at ti.com>
---
 .../arm64/boot/dts/ti/k3-j7200-common-proc-board.dts | 12 +++++++++++-
 1 file changed, 11 insertions(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts
index 2721137d8943..7110ef3e4092 100644
--- a/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts
+++ b/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts
@@ -154,16 +154,26 @@ exp2: gpio at 22 {
 	};
 };
 
+/*
+ * The j7200 CPB board is identical to the CPB used for J721E, the SOMs can be
+ * swapped on the CPB.
+ *
+ * main_i2c1 of J7200 is connected to the CPB i2c bus labeled as i2c3.
+ * The i2c1 of the CPB (as it is labeled) is not connected to j7200.
+ */
 &main_i2c1 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&main_i2c1_pins_default>;
 	clock-frequency = <400000>;
 
-	exp4: gpio at 20 {
+	exp3: gpio at 20 {
 		compatible = "ti,tca6408";
 		reg = <0x20>;
 		gpio-controller;
 		#gpio-cells = <2>;
+		gpio-line-names = "CODEC_RSTz", "CODEC_SPARE1", "UB926_RESETn",
+				  "UB926_LOCK", "UB926_PWR_SW_CNTRL",
+				  "UB926_TUNER_RESET", "UB926_GPIO_SPARE", "";
 	};
 };
 
-- 
Peter

Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki.
Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki