[PATCH 7/9] iio: adc: at91_adc: use devm_input_allocate_device

Jonathan Cameron jic23 at kernel.org
Sat Nov 14 12:13:40 EST 2020


On Fri, 13 Nov 2020 22:26:48 +0100
Alexandre Belloni <alexandre.belloni at bootlin.com> wrote:

> Use devm_input_allocate_device to allocate the input device to simplify the
> error and remove paths.
> 
> Signed-off-by: Alexandre Belloni <alexandre.belloni at bootlin.com>

This one I'm less keen on.  Whilst it's obviously not a problem in
this particular case I'd ideally like to keep the remove order
as the exact reverse of probe - that makes it easy to review changes
quickly.

Now, you could easily enough make this fine by using devm for the
other items that happen before this (dev_add_action_or_reset needed
in a few cases).

Jonathan

> ---
>  drivers/iio/adc/at91_adc.c | 25 +++----------------------
>  1 file changed, 3 insertions(+), 22 deletions(-)
> 
> diff --git a/drivers/iio/adc/at91_adc.c b/drivers/iio/adc/at91_adc.c
> index 76aeebce6f4d..d09ceb315c5a 100644
> --- a/drivers/iio/adc/at91_adc.c
> +++ b/drivers/iio/adc/at91_adc.c
> @@ -937,9 +937,8 @@ static int at91_ts_register(struct iio_dev *idev,
>  {
>  	struct at91_adc_state *st = iio_priv(idev);
>  	struct input_dev *input;
> -	int ret;
>  
> -	input = input_allocate_device();
> +	input = devm_input_allocate_device(&pdev->dev);
>  	if (!input) {
>  		dev_err(&idev->dev, "Failed to allocate TS device!\n");
>  		return -ENOMEM;
> @@ -964,8 +963,7 @@ static int at91_ts_register(struct iio_dev *idev,
>  		if (st->touchscreen_type != ATMEL_ADC_TOUCHSCREEN_4WIRE) {
>  			dev_err(&pdev->dev,
>  				"This touchscreen controller only support 4 wires\n");
> -			ret = -EINVAL;
> -			goto err;
> +			return -EINVAL;
>  		}
>  
>  		input_set_abs_params(input, ABS_X, 0, (1 << MAX_RLPOS_BITS) - 1,
> @@ -977,20 +975,7 @@ static int at91_ts_register(struct iio_dev *idev,
>  	st->ts_input = input;
>  	input_set_drvdata(input, st);
>  
> -	ret = input_register_device(input);
> -	if (ret)
> -		goto err;
> -
> -	return ret;
> -
> -err:
> -	input_free_device(st->ts_input);
> -	return ret;
> -}
> -
> -static void at91_ts_unregister(struct at91_adc_state *st)
> -{
> -	input_unregister_device(st->ts_input);
> +	return input_register_device(input);
>  }
>  
>  static int at91_adc_probe(struct platform_device *pdev)
> @@ -1203,8 +1188,6 @@ static int at91_adc_probe(struct platform_device *pdev)
>  	if (!st->touchscreen_type) {
>  		at91_adc_trigger_remove(idev);
>  		at91_adc_buffer_remove(idev);
> -	} else {
> -		at91_ts_unregister(st);
>  	}
>  error_disable_adc_clk:
>  	clk_disable_unprepare(st->adc_clk);
> @@ -1224,8 +1207,6 @@ static int at91_adc_remove(struct platform_device *pdev)
>  	if (!st->touchscreen_type) {
>  		at91_adc_trigger_remove(idev);
>  		at91_adc_buffer_remove(idev);
> -	} else {
> -		at91_ts_unregister(st);
>  	}
>  	clk_disable_unprepare(st->adc_clk);
>  	clk_disable_unprepare(st->clk);




More information about the linux-arm-kernel mailing list