[PATCH 0/8] Add R5F nodes on TI K3 AM65x and J721E SoCs

Suman Anna s-anna at ti.com
Fri Nov 6 09:26:17 EST 2020


On 11/6/20 5:43 AM, Lokesh Vutla wrote:
> 
> 
> On 29/10/20 9:07 am, Suman Anna wrote:
>> Hi Nishanth,
>>
>> The TI K3 R5F remoteproc driver and bindings were merged into 5.10-rc1,
>> and this series adds the follow-on base dt nodes for the R5F remote
>> processors on TI K3 AM65x and J721E SoCs. Additional memory nodes were
>> also added to boot these processors successfully on applicable TI K3
>> AM65x and J721E EVM boards. The series uses previously accepted mailbox
>> nodes.
>>
>> The patches follow slightly different convention between AM65x and
>> J721E. The reserved-memory nodes are added directly in the relevant
>> board dts file for AM65x boards, while they are added in the common
>> k3-j721e-som-p0.dtsi file for J721E SoCs following the similar addition
>> of K3 C66x and C71x DSP nodes in 5.10-rc1.
>>
>> Patches apply on top of your 5.10-rc1 based staging branch.
>>
>> I have validated the IPC functionality using System Firmware v2020.04a
>> and corresponding IPC example firmwares. 
> 
> 
> Series looks good to me.
> 
> Reviewed-by: Lokesh Vutla <lokeshvutla at ti.com>
>

Thanks Lokesh.


> On a side note: any reason not to add R5f nodes for J7200?

J7200 nodes would have to wait until the corresponding dt-bindings and driver
updates make it into mainline. They do use different compatibles, and I will
post them in the next couple of weeks.

regards
Suman



More information about the linux-arm-kernel mailing list