[PATCH v2 9/9] arm64: dts: marvell: armada-cp110: Switch to per-port SATA interrupts

[sven.auhagen at voleatech.de]

From: Sven Auhagen <sven.auhagen at voleatech.de>

There are two SATA ports per CP110. Each of them has a dedicated
interrupt. Describe the real hardware by adding two SATA ports to the
CP110 SATA node.

Reviewed-by: Hans de Goede <hdegoede at redhat.com>
Signed-off-by: Sven Auhagen <sven.auhagen at voleatech.de>
Signed-off-by: Thomas Petazzoni <thomas.petazzoni at bootlin.com>
Signed-off-by: Miquel Raynal <miquel.raynal at bootlin.com>
---
 arch/arm64/boot/dts/marvell/armada-cp11x.dtsi | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/arch/arm64/boot/dts/marvell/armada-cp11x.dtsi b/arch/arm64/boot/dts/marvell/armada-cp11x.dtsi
index 9dcf16beabf5..ec27294f097b 100644
--- a/arch/arm64/boot/dts/marvell/armada-cp11x.dtsi
+++ b/arch/arm64/boot/dts/marvell/armada-cp11x.dtsi
@@ -300,11 +300,9 @@
 		};
 
 		CP11X_LABEL(sata0): sata at 540000 {
-			compatible = "marvell,armada-8k-ahci",
-			"generic-ahci";
+			compatible = "marvell,armada-8k-ahci";
 			reg = <0x540000 0x30000>;
 			dma-coherent;
-			interrupts = <107 IRQ_TYPE_LEVEL_HIGH>;
 			clocks = <&CP11X_LABEL(clk) 1 15>,
 				 <&CP11X_LABEL(clk) 1 16>;
 			#address-cells = <1>;
@@ -312,10 +310,12 @@
 			status = "disabled";
 
 			sata-port at 0 {
+				interrupts = <109 IRQ_TYPE_LEVEL_HIGH>;
 				reg = <0>;
 			};
 
 			sata-port at 1 {
+				interrupts = <107 IRQ_TYPE_LEVEL_HIGH>;
 				reg = <1>;
 			};
 		};
-- 
2.20.1