[PATCH] ARM: dts: sun7i: bananapi: Enable RGMII RX/TX delay on Ethernet PHY

[Pablo Sebastián Greco]

On 2/11/20 11:07, Maxime Ripard wrote:
> Hi,
>
> On Sat, Oct 31, 2020 at 09:34:15PM -0300, Pablo Greco wrote:
>> The Ethernet PHY on the Bananapi M1 has the RX and TX delays enabled on
>> the PHY, using pull-ups on the RXDLY and TXDLY pins.
>>
>> Fix the phy-mode description to correct reflect this so that the
>> implementation doesn't reconfigure the delays incorrectly. This
>> happened with commit bbc4d71d6354 ("net: phy: realtek: fix rtl8211e
>> rx/tx delay config").
>>
>> Fixes: 8a5b272fbf44 ("ARM: dts: sun7i: Add Banana Pi board")
>> Signed-off-by: Pablo Greco <pgreco at centosproject.org>
> Thanks for sending those patches.
>
> However, I'm not entirely sure how you sent it but the odd threading you
> used (each other patches being in reply to this one without 0/N in the
> name) seem to confuse the tools we use to apply the patches.
>
> Can you resend it properly?
> Thanks!
> Maxime
I prepared them individually but sent them together in a single 
git-send-email, that must have been the problem.
I"ll send them again one by one.

Pablo.