[PATCH v5 4/9] ARM: dts: bcm2711: Add reset controller to xHCI node

[Florian Fainelli]

On 6/29/2020 9:18 AM, Nicolas Saenz Julienne wrote:
> The chip is hardwired to the board's PCIe bus and needs to be properly
> setup trough a firmware routine after a PCI fundamental reset. Pass the
> reset controller phandle that takes care of triggering the
> initialization to the relevant PCI device.
> 
> Signed-off-by: Nicolas Saenz Julienne <nsaenzjulienne at suse.de>

Reviewed-by: Florian Fainelli <f.fainelli at gmail.com>
-- 
Florian