[PATCH 3/3] ARM: imx: Select RESET_IMX7 for i.MX7D

[Arnd Bergmann]

On Mon, Jun 29, 2020 at 1:54 PM Anson Huang <anson.huang at nxp.com> wrote:
> > Subject: Re: [PATCH 3/3] ARM: imx: Select RESET_IMX7 for i.MX7D
> >
> > On Mon, Jun 29, 2020 at 1:36 PM Anson Huang <anson.huang at nxp.com>
> > wrote:
> > > > Subject: Re: [PATCH 3/3] ARM: imx: Select RESET_IMX7 for i.MX7D
> > > > On Mon, Jun 29, 2020 at 12:25 PM Anson Huang
> > <Anson.Huang at nxp.com> wrote:

> > I don't understand. Why can't this driver be a loadable module on i.MX7?
> > Please clarify in the changelog what the bug is on i.MX7.
> >
> > > ARMv7 SoCs is NOT in the plan, that is why I add this patch to make it
> > > same as previously when this reset driver is =y by default. Without
> > > this patch, this reset driver will NOT be enabled by default for i.MX ARMv7
> > SoCs, function will be broken.
> >
> > But it's the same driver, make it work the same way on all chips!
> >
> > I think artificially limiting a new driver feature to one chip just because nobody
> > asked for it on another chip is not helpful.
> >
>
> Understood, what if I don't select it in SOC config which is NOT flexible, but put it in
> imx_v6_v7_defconfig, then user can select either =y or =m according their requirement?

I would recommend using a 'default m if SOC_IMX7' or 'default y if SOC_IMX7', so
any distros and users that have their own defconfigs still get a reasonable
default, but can choose between =m and =y based on their needs.

> And in imx_v6_v7_defconfig make it =y by default.

Having =y in imx_v6_v7_defconfig sounds reasonable if you go with 'default m'.

     Arnd