[PATCH v5 00/10] irqchip: ti, sci-intr/inta: Update the dt bindings to accept different interrupt parents

[Rob Herring]

On Fri, Jul 31, 2020 at 01:24:17PM -0500, Suman Anna wrote:
> On 7/31/20 1:16 PM, Rob Herring wrote:
> > On Fri, Jul 31, 2020 at 06:01:50PM +0100, Marc Zyngier wrote:
> > > On 2020-07-28 06:17, Lokesh Vutla wrote:
> > > > Hi Marc,
> > > > 	This is continuation of the RFC patches[0] regarding the driver
> > > > updates to support for following interrupt parent connection:
> > > > - INTR -> INTR
> > > > - INTA -> GICv3
> > > > The current existing driver assumes that INTR is always connected to
> > > > GICv3 and INTA is always connected to INTR.
> > > 
> > > I'm OK to take this if I can get an Ack from RobH on the three
> > > DT patches that still need it.
> > 
> > Reviewed-by: Rob Herring <robh at kernel.org>
> > 
> > However, there's a dependency on
> > bindings/arm/keystone/ti,k3-sci-common.yaml.
> > 
> > That's a dependency on this being merged. I don't care if it breaks in
> > your tree, but I care for -next and Linus' tree. There could also be
> > other 'make dt_bindings_check' failures/warnings with this as the above
> > dependency prevents further testing.
> > 
> 
> Bjorn did pick up the above common binding file through the remoteproc tree,
> and it is available in -next. That said, I donno the merge order between
> remoteproc and irq subsystem trees into -next, and if that is a concern.

I'm less concerned about merge order at this point. -rc1 not being 
broken is the low bar I have...

Rob