[PATCH 1/1] iommu/arm-smmu: Implement qcom,skip-init
Bjorn Andersson
bjorn.andersson at linaro.org
Fri Jul 31 01:48:50 EDT 2020
On Wed 22 Jul 13:11 PDT 2020, Konrad Dybcio wrote:
> >Is the problem on SDM630 that when you write to SMR/S2CR the device
> >reboots? Or that when you start writing out the context bank
> >configuration that trips the display and the device reboots?
>
> I added some debug prints and the phone hangs after reaching the
> seventh CB (with i=6) at
>
> arm_smmu_cb_write(smmu, i, ARM_SMMU_CB_FSR, ARM_SMMU_FSR_FAULT);
>
> line in arm_smmu_device_reset.
>
Sounds like things are progressing nicely for a while there, presumably
until the next time the display is being refreshed.
Would you be willing to try out the following work in progress:
https://lore.kernel.org/linux-arm-msm/20200717001619.325317-1-bjorn.andersson@linaro.org/
You need to adjust drivers/iommu/arm-smmu-impl.c so that
arm_smmu_impl_init() will invoke qcom_smmu_impl_init() as it spots your
apps smmu.
Regards,
Bjorn
More information about the linux-arm-kernel
mailing list