[PATCH v2 2/5] iommu/arm-smmu: Emulate bypass by using context banks

[Will Deacon]

On Thu, Jul 16, 2020 at 05:16:16PM -0700, Bjorn Andersson wrote:
> Some firmware found on various Qualcomm platforms traps writes to S2CR
> of type BYPASS and writes FAULT into the register. This prevents us from
> marking the streams for the display controller as BYPASS to allow
> continued scanout of the screen through the initialization of the ARM
> SMMU.
> 
> This adds a Qualcomm specific cfg_probe function, which probes the
> behavior of the S2CR registers and if found faulty enables the related
> quirk. Based on this quirk context banks are allocated for IDENTITY
> domains as well, but with ARM_SMMU_SCTLR_M omitted.
> 
> The result is valid stream mappings, without translation.
> 
> Tested-by: John Stultz <john.stultz at linaro.org>
> Tested-by: Vinod Koul <vkoul at kernel.org>
> Signed-off-by: Bjorn Andersson <bjorn.andersson at linaro.org>
> ---
> 
> Changes since v1:
> - Picked up tested-by
> 
>  drivers/iommu/arm-smmu-qcom.c | 21 +++++++++++++++++++++
>  drivers/iommu/arm-smmu.c      | 14 ++++++++++++--
>  drivers/iommu/arm-smmu.h      |  3 +++
>  3 files changed, 36 insertions(+), 2 deletions(-)

[...]

> diff --git a/drivers/iommu/arm-smmu.c b/drivers/iommu/arm-smmu.c
> index fb85e716ae9a..5d5fe6741ed4 100644
> --- a/drivers/iommu/arm-smmu.c
> +++ b/drivers/iommu/arm-smmu.c
> @@ -654,7 +654,9 @@ static void arm_smmu_write_context_bank(struct arm_smmu_device *smmu, int idx)
>  
>  	/* SCTLR */
>  	reg = ARM_SMMU_SCTLR_CFIE | ARM_SMMU_SCTLR_CFRE | ARM_SMMU_SCTLR_AFE |
> -	      ARM_SMMU_SCTLR_TRE | ARM_SMMU_SCTLR_M;
> +	      ARM_SMMU_SCTLR_TRE;
> +	if (cfg->m)
> +		reg |= ARM_SMMU_SCTLR_M;
>  	if (stage1)
>  		reg |= ARM_SMMU_SCTLR_S1_ASIDPNE;
>  	if (IS_ENABLED(CONFIG_CPU_BIG_ENDIAN))
> @@ -678,7 +680,11 @@ static int arm_smmu_init_domain_context(struct iommu_domain *domain,
>  	if (smmu_domain->smmu)
>  		goto out_unlock;
>  
> -	if (domain->type == IOMMU_DOMAIN_IDENTITY) {
> +	/*
> +	 * Nothing to do for IDENTITY domains,unless disabled context banks are
> +	 * used to emulate bypass mappings on Qualcomm platforms.
> +	 */
> +	if (domain->type == IOMMU_DOMAIN_IDENTITY && !smmu->qcom_bypass_quirk) {

Given that the other thread [1] with Jordan (why haven't you cc'd him?! --
adding him now) has identified the need for a callback to allocate the
context bank, why don't we use the same sort of idea here? If the impl
provides a CB allocator function, call it irrespective of the domain type.
If it allocates a domain even for an identity domain, then we can install
if with SCTLR.M clear.

Will

[1] https://lore.kernel.org/r/20200716151625.GA14526@jcrouse1-lnx.qualcomm.com