[PATCH v7 10/10] arm64: dts: actions: Add uSD support for Cubieboard7

Amit Singh Tomar amittomer25 at gmail.com
Sun Jul 19 13:42:07 EDT 2020


This commit adds uSD support for Cubieboard7 board based on Actions Semi
S700 SoC. SD0 is connected to uSD slot. Since there is no PMIC support
added yet, fixed regulator has been used as a regulator node.

Signed-off-by: Amit Singh Tomar <amittomer25 at gmail.com>
---
Changes since v6:
	* Brought back the uSD fixed regulator.
Changes since v5:
        * Removed the Fixed regulators as these are
          not needed.
Changes since v4:
        * No change.
Changes since v3:
        * No change.
Changes since v2:
        * No change.
Changes since v1:
        * No change.
Changes since RFC:
        * No change.
---
 arch/arm64/boot/dts/actions/s700-cubieboard7.dts | 33 ++++++++++++++++++++++++
 arch/arm64/boot/dts/actions/s700.dtsi            |  1 +
 2 files changed, 34 insertions(+)

diff --git a/arch/arm64/boot/dts/actions/s700-cubieboard7.dts b/arch/arm64/boot/dts/actions/s700-cubieboard7.dts
index 63e375cd9eb4..f81d63261ba2 100644
--- a/arch/arm64/boot/dts/actions/s700-cubieboard7.dts
+++ b/arch/arm64/boot/dts/actions/s700-cubieboard7.dts
@@ -13,6 +13,7 @@
 
 	aliases {
 		serial3 = &uart3;
+		mmc0 = &mmc0;
 	};
 
 	chosen {
@@ -28,6 +29,15 @@
 		device_type = "memory";
 		reg = <0x1 0xe0000000 0x0 0x0>;
 	};
+
+	/* Fixed regulator used in the absence of PMIC */
+	sd_vcc: sd-vcc {
+		compatible = "regulator-fixed";
+		regulator-name = "fixed-3.1V";
+		regulator-min-microvolt = <3100000>;
+		regulator-max-microvolt = <3100000>;
+		regulator-always-on;
+	};
 };
 
 &i2c0 {
@@ -81,6 +91,14 @@
 			bias-pull-up;
 		};
 	};
+
+	mmc0_default: mmc0_default {
+		pinmux {
+			groups = "sd0_d0_mfp", "sd0_d1_mfp", "sd0_d2_d3_mfp",
+				 "sd0_cmd_mfp", "sd0_clk_mfp";
+			function = "sd0";
+		};
+	};
 };
 
 &timer {
@@ -90,3 +108,18 @@
 &uart3 {
 	status = "okay";
 };
+
+/* uSD */
+&mmc0 {
+	status = "okay";
+	pinctrl-names = "default";
+	pinctrl-0 = <&mmc0_default>;
+	cd-gpios = <&pinctrl 120 GPIO_ACTIVE_LOW>;
+	no-sdio;
+	no-mmc;
+	no-1-8-v;
+	bus-width = <4>;
+	vmmc-supply = <&sd_vcc>;
+	vqmmc-supply = <&sd_vcc>;
+};
+
diff --git a/arch/arm64/boot/dts/actions/s700.dtsi b/arch/arm64/boot/dts/actions/s700.dtsi
index 9ed88aafc2da..ba498cf9217d 100644
--- a/arch/arm64/boot/dts/actions/s700.dtsi
+++ b/arch/arm64/boot/dts/actions/s700.dtsi
@@ -4,6 +4,7 @@
  */
 
 #include <dt-bindings/clock/actions,s700-cmu.h>
+#include <dt-bindings/gpio/gpio.h>
 #include <dt-bindings/interrupt-controller/arm-gic.h>
 #include <dt-bindings/power/owl-s700-powergate.h>
 #include <dt-bindings/reset/actions,s700-reset.h>
-- 
2.7.4




More information about the linux-arm-kernel mailing list