[PATCH v2 2/2] memory: samsung: exynos5422-dmc: Add module param to control IRQ mode

[Lukasz Luba]

On 7/14/20 10:01 AM, Lukasz Luba wrote:
> Hi Bartek,
> 
> On 7/14/20 8:42 AM, Bartlomiej Zolnierkiewicz wrote:
>>
>> Hi,
>>
>> On 7/10/20 9:11 PM, Lukasz Luba wrote:
>>> The driver can operate in two modes relaying on devfreq monitoring
>>> mechanism which periodically checks the device status or it can use
>>> interrupts when they are provided by loaded Device Tree. The newly
>>> introduced module parameter can be used to choose between devfreq
>>> monitoring and internal interrupts without modifying the Device Tree.
>>> It also sets devfreq monitoring as default when the parameter is not set
>>> (also the case for default when the driver is not built as a module).
>>
>> Could you please explain why should we leave the IRQ mode
>> support in the dmc driver?
> 
> I am still experimenting with the IRQ mode in DMC, but have limited time
> for it and no TRM.
> The IRQ mode in memory controller or bus controller has one major
> advantage: is more interactive. In polling we have fixed period, i.e.
> 100ms - that's a lot when we have a sudden, latency sensitive workload.
> There might be no check of the device load for i.e. 99ms, but the tasks
> with such workload started running. That's a long period of a few frames
> which are likely to be junked. Should we adjust polling interval to i.e.
> 10ms, I don't think so. There is no easy way to address all of the
> scenarios.
> 
>>
>> What are the advantages over the polling mode?
> 
> As described above: more reactive to sudden workload, which might be
> latency sensitive and cause junk frames.
> Drawback: not best in benchmarks which are randomly jumping
> over the data set, causing low traffic on memory.
> It could be mitigated as Sylwester described with not only one type
> of interrupt, but another, which could 'observe' also other information
> type in the counters and fire.
> 
>>
>> In what scenarios it should be used?
> 
> System like Android with GUI, when there is this sudden workload
> quite often.
> 
> I think the interconnect could help here and would adjust the DMC
> freq upfront. Although I don't know if interconnect on Exynos5422 is in
> your scope in near future. Of course the interconnect will not cover
> all scenarios either.
> 
> 
>>
>> [ If this is only for documentation purposes then it should be
>>    removed as it would stay in (easily accessible) git history
>>    anyway.. ]
> 
> The current interrupt mode is definitely not perfect and switching
> to devfreq monitoring mode has more sense. On the other hand, it
> still has potential, until there is no interconnect for this SoC.
> I will continue experimenting with irq mode, so I would like to
> still have the code in the driver.
> 
> Regards,
> Lukasz
> 
>>
>> Best regards,
>> -- 
>> Bartlomiej Zolnierkiewicz
>> Samsung R&D Institute Poland
>> Samsung Electronics
>>

Bartek, do you have some objections to the patches or you think
they can be taken via devfreq-next?

Cheers,
Lukasz