[PATCH v4 08/16] thermal: sun8i: add TEMP_CALIB_MASK for calibration data in sun50i_h6_ths_calibrate

[Daniel Lezcano]

On 14/07/2020 09:13, Frank Lee wrote:
> From: Yangtao Li <frank at allwinnertech.com>
> 
> For sun50i_h6_ths_calibrate(), the data read from nvmem needs a round of
> calculation. On the other hand, the newer SOC may store other data in
> the space other than 12bit sensor data. Add mask operation to read data
> to avoid conversion error.
> 
> Signed-off-by: Yangtao Li <frank at allwinnertech.com>
> Reviewed-by: Yangtao Li <tiny.windzz at gmail.com>

Can you clarify these SoB ?

Frank Lee==Yangtao Li==frank at allwinnertech.com==tiny.windzz at gmail.com ?



> ---
>  drivers/thermal/sun8i_thermal.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/drivers/thermal/sun8i_thermal.c b/drivers/thermal/sun8i_thermal.c
> index 74d73be16496..f423d44b9290 100644
> --- a/drivers/thermal/sun8i_thermal.c
> +++ b/drivers/thermal/sun8i_thermal.c
> @@ -244,7 +244,7 @@ static int sun50i_h6_ths_calibrate(struct ths_device *tmdev,
>  	ft_temp = (caldata[0] & FT_TEMP_MASK) * 100;
>  
>  	for (i = 0; i < tmdev->chip->sensor_num; i++) {
> -		int sensor_reg = caldata[i + 1];
> +		int sensor_reg = caldata[i + 1] & TEMP_CALIB_MASK;
>  		int cdata, offset;
>  		int sensor_temp = tmdev->chip->calc_temp(tmdev, i, sensor_reg);
>  
> 


-- 
<http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs

Follow Linaro:  <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog