[PATCH v2 1/2] ARM: dts: imx6qdl-sabresd: Add an mdio node

[Fabio Estevam]

imx6qdl-sabresd has an Atheros AR8031 Ethernet PHY at address 1.

The AR8031 provides a 125MHz clock to the ENET_REF_CLK i.MX6 pin.

Improve the Ethernet representation by adding an mdio node with such
information.

An advantage of adding the mdio node is that the AR8031 initialization
code in the mx6sabresd board file in U-Boot can totally be removed.

Signed-off-by: Fabio Estevam <festevam at gmail.com>
---
Changes since v1:
- None. Only inverted the order of the patches

 arch/arm/boot/dts/imx6qdl-sabresd.dtsi | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/arch/arm/boot/dts/imx6qdl-sabresd.dtsi b/arch/arm/boot/dts/imx6qdl-sabresd.dtsi
index 28b35ccb3757..6524ad4b0010 100644
--- a/arch/arm/boot/dts/imx6qdl-sabresd.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-sabresd.dtsi
@@ -203,9 +203,20 @@
 	pinctrl-names = "default";
 	pinctrl-0 = <&pinctrl_enet>;
 	phy-mode = "rgmii-id";
+	phy-handle = <&phy>;
 	phy-reset-gpios = <&gpio1 25 GPIO_ACTIVE_LOW>;
 	fsl,magic-packet;
 	status = "okay";
+
+	mdio {
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		phy: ethernet-phy at 1 {
+			reg = <1>;
+			qca,clk-out-frequency = <125000000>;
+		};
+	};
 };
 
 &hdmi {
-- 
2.17.1