[PATCH] arm64: dts: ls1043a: update USB nodes status to match board config

[Shawn Guo]

On Tue, Jul 07, 2020 at 03:40:31PM +0800, Ran Wang wrote:
> ls1043a-rdb and ls1043a-qds board’s default HW config (such as
> pin mux selection) would not enable some USB controllers’
> data path, which causing over-current detected on those
> controllers. This will hit the case of ‘xhci driver prevent bus suspend
> if a root hub port detected over-current condition’, causing system
> failed to be suspended. So disable them in device tree to resolve this
> issue.
> 
> Signed-off-by: Ran Wang <ran.wang_1 at nxp.com>

Applied, thanks.