[PATCH v7 02/13] dt-bindings: panel: Convert rocktech, jh057n00900 to yaml

[Ondřej Jirman]

On Fri, Jul 03, 2020 at 12:44:48PM +0200, megous hlavni wrote:
> Hello Sam,
> 
> On Fri, Jul 03, 2020 at 07:11:55AM +0200, Sam Ravnborg wrote:
> > Hi Ondrej.
> > 
> > > > My bot found errors running 'make dt_binding_check' on your patch:
> > > > 
> > > > /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/display/bridge/nwl-dsi.example.dt.yaml: panel at 0: '#address-cells', '#size-cells', 'port at 0' do not match any of the regexes: 'pinctrl-[0-9]+'
> > > > /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/display/bridge/nwl-dsi.example.dt.yaml: panel at 0: 'vcc-supply' is a required property
> > > > /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/display/bridge/nwl-dsi.example.dt.yaml: panel at 0: 'iovcc-supply' is a required property
> > > > /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/display/bridge/nwl-dsi.example.dt.yaml: panel at 0: 'reset-gpios' is a required property
> > > 
> > > Paths look bogus ^^^^
> > > 
> > > It should be .../rocktech,jh057n00900.yaml: ...
> > 
> > The example in nwl-dsi.yaml contains:
> > 	compatible = "rocktech,jh057n00900";
> > 
> > So the example is checked against your updated binding.
> > And the binding check fails because the example is no longer valid.
> 
> Ah, now I understand.
> 
> > This needs to be fixed as we do not wat to introduce new errors.
> > Either the example or the binding needs the fix.
> 
> I think we can unrequire the supplies, but reset is needed really.

Hmm, that's probably wrong kind of thinking. Panel has the supplies, and
obviously requires them, so the dts must describe them somehow, even if
they are the fixed supplies. So I'll not unrequire them.

> The panel only has one port, so there should be no address/size-cells
> in the example, and port at 0 should be just port to match existing binding.
> If it had  multiple ports, port at 0 would have to be inside ports { } node
> anyway, according to the existing binding. Then add reset-gpios to
> the example...
> 
> And that should fix it.
> 
> I'll prepare the patch shortly.
> 
> regards,
> 	o.
> 
> > 	Sam
> > 
> > 
> > > 
> > > regards,
> > > 	o.
> > > 
> > > > 
> > > > See https://patchwork.ozlabs.org/patch/1320690
> > > > 
> > > > If you already ran 'make dt_binding_check' and didn't see the above
> > > > error(s), then make sure dt-schema is up to date:
> > > > 
> > > > pip3 install git+https://github.com/devicetree-org/dt-schema.git@master --upgrade
> > > > 
> > > > Please check and re-submit.
> > > >