[PATCH v3 3/4] ARM: dts: sun8i-a83t-tbs-a711: Add support for the vibrator motor

[Ondrej Jirman]

The board has a vibrator mottor. Hook it to the input subsystem.

According to the PMIC specification, LDO needs to be enabled (value 0b11)
to achieve the specified max driving current of 150mA. We can't drive
the motor with just GPIO mode.

In GPIO mode the chip is probably just using the regular CMOS logic
output circuitry (typically limited to around 20-35mA, but not specified
in this datasheet).

Signed-off-by: Ondrej Jirman <megous at megous.com>
---
 arch/arm/boot/dts/sun8i-a83t-tbs-a711.dts | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/arch/arm/boot/dts/sun8i-a83t-tbs-a711.dts b/arch/arm/boot/dts/sun8i-a83t-tbs-a711.dts
index bfc9bb277a49..a278a1e33930 100644
--- a/arch/arm/boot/dts/sun8i-a83t-tbs-a711.dts
+++ b/arch/arm/boot/dts/sun8i-a83t-tbs-a711.dts
@@ -99,6 +99,11 @@ panel_input: endpoint {
 		};
 	};
 
+	vibrator {
+		compatible = "gpio-vibrator";
+		vcc-supply = <&reg_ldo_io1>;
+	};
+
 	reg_gps: reg-gps {
 		compatible = "regulator-fixed";
 		regulator-name = "gps";
-- 
2.27.0