[PATCH] arm64: arch_k3: enable chipid driver
Grygorii Strashko
grygorii.strashko at ti.com
Wed Jul 1 06:18:24 EDT 2020
hi All,
On 19/06/2020 19:25, Grygorii Strashko wrote:
> Select TI chip id driver for TI's SoCs based on K3 architecture to provide
> this information to user space and Kernel as it is required by other
> drivers to determine SoC revision to function properly.
>
> Signed-off-by: Grygorii Strashko <grygorii.strashko at ti.com>
> Reviewed-by: Lokesh Vutla <lokeshvutla at ti.com>
> ---
> arch/arm64/Kconfig.platforms | 1 +
> 1 file changed, 1 insertion(+)
>
> diff --git a/arch/arm64/Kconfig.platforms b/arch/arm64/Kconfig.platforms
> index 8dd05b2a925c..1d3710e3626a 100644
> --- a/arch/arm64/Kconfig.platforms
> +++ b/arch/arm64/Kconfig.platforms
> @@ -98,6 +98,7 @@ config ARCH_K3
> select TI_SCI_PROTOCOL
> select TI_SCI_INTR_IRQCHIP
> select TI_SCI_INTA_IRQCHIP
> + select TI_K3_SOCINFO
> help
> This enables support for Texas Instruments' K3 multicore SoC
> architecture.
>
Are there any comments?
The driver and dt changes were merged [1][2] and for adding new am654x SoC
revision SR2.0 we need this driver to be enabled always as other drivers are
going to use SOC Bus API intensively.
No dependencies.
[1] https://lore.kernel.org/lkml/20200512123449.16517-1-grygorii.strashko@ti.com/
[2] https://lore.kernel.org/lkml/20200613164346.28852-1-grygorii.strashko@ti.com/
--
Best regards,
grygorii
More information about the linux-arm-kernel
mailing list