[PATCH 2/2] ARM: dts: stm32: Fix GPIO hog flags on DHCOM DRC02

[Marek Vasut]

The GPIO hog flags are ignored by gpiolib-of.c now, set the flags to 0.
Since GPIO_ACTIVE_HIGH is defined as 0, this change only increases the
correctness of the DT.

Fixes: fde180f06d7b ("ARM: dts: stm32: Add DHSOM based DRC02 board")
Signed-off-by: Marek Vasut <marex at denx.de>
Cc: Alexandre Torgue <alexandre.torgue at st.com>
Cc: Maxime Coquelin <mcoquelin.stm32 at gmail.com>
Cc: Patrice Chotard <patrice.chotard at st.com>
Cc: Patrick Delaunay <patrick.delaunay at st.com>
Cc: linux-stm32 at st-md-mailman.stormreply.com
To: linux-arm-kernel at lists.infradead.org
---
 arch/arm/boot/dts/stm32mp15xx-dhcom-drc02.dtsi | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boot/dts/stm32mp15xx-dhcom-drc02.dtsi b/arch/arm/boot/dts/stm32mp15xx-dhcom-drc02.dtsi
index 6a2b546f6f72..8d1fea332665 100644
--- a/arch/arm/boot/dts/stm32mp15xx-dhcom-drc02.dtsi
+++ b/arch/arm/boot/dts/stm32mp15xx-dhcom-drc02.dtsi
@@ -35,7 +35,7 @@ &gpiob {
 	 */
 	rs485-rx-en-hog {
 		gpio-hog;
-		gpios = <8 GPIO_ACTIVE_HIGH>;
+		gpios = <8 0>;
 		output-low;
 		line-name = "rs485-rx-en";
 	};
@@ -63,7 +63,7 @@ &gpioi {
 	 */
 	usb-hub-hog {
 		gpio-hog;
-		gpios = <2 GPIO_ACTIVE_HIGH>;
+		gpios = <2 0>;
 		output-high;
 		line-name = "usb-hub-reset";
 	};
-- 
2.29.2