[PATCH v3 3/4] arm64: dts: cn913x: add device trees for topology B boards

[Andrew Lunn]

> -	cp0_sfp_eth0: sfp-eth at 0 {
> -		compatible = "sff,sfp";
> -		i2c-bus = <&cp0_sfpp0_i2c>;
> -		los-gpio = <&cp0_module_expander1 11 GPIO_ACTIVE_HIGH>;
> -		mod-def0-gpio = <&cp0_module_expander1 10 GPIO_ACTIVE_LOW>;
> -		tx-disable-gpio = <&cp0_module_expander1 9 GPIO_ACTIVE_HIGH>;
> -		tx-fault-gpio = <&cp0_module_expander1 8 GPIO_ACTIVE_HIGH>;
> -		/*
> -		 * SFP cages are unconnected on early PCBs because of an the I2C
> -		 * lanes not being connected. Prevent the port for being
> -		 * unusable by disabling the SFP node.
> -		 */
> -		status = "disabled";

Does the B also have the broken SFP cage?

Is there a newer revision which fixes the PCB?

   Andrew