[PATCH 3/4] dt-bindings: phy: mixel: mipi-dsi-phy: Add Mixel combo PHY support for i.MX8qxp

[Liu Ying]

On Tue, 2020-12-08 at 10:07 +0100, Guido Günther wrote:
> Hi Liu,
> Since we now gain optional properties validation would become even more
> useful. Could you look into converting to YAML before adding more
> values?

Yes, a YAML one would be good.
I'll try to do the conversion and then add the binding support for the
i.MX8qxp Mixel combo PHY in it.

Liu Ying

> Cheers,
>  -- Guido
> 
> On Fri, Dec 04, 2020 at 03:33:43PM +0800, Liu Ying wrote:
> > Add support for Mixel MIPI DPHY + LVDS PHY combo IP
> > as found on Freescale i.MX8qxp SoC.
> > 
> > Cc: Guido Günther <agx at sigxcpu.org>
> > Cc: Kishon Vijay Abraham I <kishon at ti.com>
> > Cc: Vinod Koul <vkoul at kernel.org>
> > Cc: Rob Herring <robh+dt at kernel.org>
> > Cc: NXP Linux Team <linux-imx at nxp.com>
> > Signed-off-by: Liu Ying <victor.liu at nxp.com>
> > ---
> >  Documentation/devicetree/bindings/phy/mixel,mipi-dsi-phy.txt | 8 +++++++-
> >  1 file changed, 7 insertions(+), 1 deletion(-)
> > 
> > diff --git a/Documentation/devicetree/bindings/phy/mixel,mipi-dsi-phy.txt b/Documentation/devicetree/bindings/phy/mixel,mipi-dsi-phy.txt
> > index 9b23407..0afce99 100644
> > --- a/Documentation/devicetree/bindings/phy/mixel,mipi-dsi-phy.txt
> > +++ b/Documentation/devicetree/bindings/phy/mixel,mipi-dsi-phy.txt
> > @@ -4,9 +4,13 @@ The Mixel MIPI-DSI PHY IP block is e.g. found on i.MX8 platforms (along the
> >  MIPI-DSI IP from Northwest Logic). It represents the physical layer for the
> >  electrical signals for DSI.
> >  
> > +The Mixel PHY IP block found on i.MX8qxp is a combo PHY that can work
> > +in either MIPI-DSI PHY mode or LVDS PHY mode.
> > +
> >  Required properties:
> > -- compatible: Must be:
> > +- compatible: Should be one of:
> >    - "fsl,imx8mq-mipi-dphy"
> > +  - "fsl,imx8qxp-mipi-dphy"
> >  - clocks: Must contain an entry for each entry in clock-names.
> >  - clock-names: Must contain the following entries:
> >    - "phy_ref": phandle and specifier referring to the DPHY ref clock
> > @@ -14,6 +18,8 @@ Required properties:
> >  - #phy-cells: number of cells in PHY, as defined in
> >    Documentation/devicetree/bindings/phy/phy-bindings.txt
> >    this must be <0>
> > +- fsl,syscon: Phandle to a system controller, as required by the PHY
> > +  in i.MX8qxp SoC.
> >  
> >  Optional properties:
> >  - power-domains: phandle to power domain
> > -- 
> > 2.7.4
> >