[PATCH v2 3/3] edac: Supporting AST2400 and AST2600 edac driver
Troy Lee
troy_lee at aspeedtech.com
Wed Dec 2 01:36:11 EST 2020
Adding AST2400 and AST2600 edac driver support.
Signed-off-by: Troy Lee <troy_lee at aspeedtech.com>
---
Change since v1:
1. Removing SoC specific code
2. Changing numerical representation of memory sizing
---
drivers/edac/Kconfig | 6 +--
drivers/edac/aspeed_edac.c | 103 +++++++++++++++++++++++++++++--------
2 files changed, 85 insertions(+), 24 deletions(-)
diff --git a/drivers/edac/Kconfig b/drivers/edac/Kconfig
index fc30f2ef9782..8ea70746d0bf 100644
--- a/drivers/edac/Kconfig
+++ b/drivers/edac/Kconfig
@@ -508,10 +508,10 @@ config EDAC_QCOM
health, you should probably say 'Y' here.
config EDAC_ASPEED
- tristate "Aspeed AST 2500 SoC"
- depends on MACH_ASPEED_G5
+ tristate "Aspeed AST BMC SoC"
+ depends on (MACH_ASPEED_G4 || MACH_ASPEED_G5 || MACH_ASPEED_G6)
help
- Support for error detection and correction on the Aspeed AST 2500 SoC.
+ Support for error detection and correction on the Aspeed AST BMC SoC.
First, ECC must be configured in the bootloader. Then, this driver
will expose error counters via the EDAC kernel framework.
diff --git a/drivers/edac/aspeed_edac.c b/drivers/edac/aspeed_edac.c
index fbec28dc661d..b8c8d6a05f91 100644
--- a/drivers/edac/aspeed_edac.c
+++ b/drivers/edac/aspeed_edac.c
@@ -14,12 +14,11 @@
#include <linux/regmap.h>
#include "edac_module.h"
-
#define DRV_NAME "aspeed-edac"
-
#define ASPEED_MCR_PROT 0x00 /* protection key register */
#define ASPEED_MCR_CONF 0x04 /* configuration register */
+#define ASPEED_MCR_REQ 0x08 /* Graphics Memory Protection register */
#define ASPEED_MCR_INTR_CTRL 0x50 /* interrupt control/status register */
#define ASPEED_MCR_ADDR_UNREC 0x58 /* address of first un-recoverable error */
#define ASPEED_MCR_ADDR_REC 0x5c /* address of last recoverable error */
@@ -29,15 +28,17 @@
#define ASPEED_MCR_PROT_PASSWD 0xfc600309
#define ASPEED_MCR_CONF_DRAM_TYPE BIT(4)
#define ASPEED_MCR_CONF_ECC BIT(7)
+#define ASPEED_MCR_CONF_DRAM_CTRL_TYPE (BIT(28)|BIT(29)|BIT(30)|BIT(31))
#define ASPEED_MCR_INTR_CTRL_CLEAR BIT(31)
#define ASPEED_MCR_INTR_CTRL_CNT_REC GENMASK(23, 16)
#define ASPEED_MCR_INTR_CTRL_CNT_UNREC GENMASK(15, 12)
#define ASPEED_MCR_INTR_CTRL_ENABLE (BIT(0) | BIT(1))
+#define ASPEED_MCR_CONF_DRAM_CTRL_TYPE_AST2500 0x01
+#define ASPEED_MCR_CONF_DRAM_CTRL_TYPE_AST2600 0x03
static struct regmap *aspeed_regmap;
-
static int regmap_reg_write(void *context, unsigned int reg, unsigned int val)
{
void __iomem *regs = (void __iomem *)context;
@@ -53,7 +54,6 @@ static int regmap_reg_write(void *context, unsigned int reg, unsigned int val)
return 0;
}
-
static int regmap_reg_read(void *context, unsigned int reg, unsigned int *val)
{
void __iomem *regs = (void __iomem *)context;
@@ -63,6 +63,79 @@ static int regmap_reg_read(void *context, unsigned int reg, unsigned int *val)
return 0;
}
+extern void aspeed_sdmc_disable_mem_protection(u8 req)
+{
+ u32 req_val = 0;
+
+ regmap_read(aspeed_regmap, ASPEED_MCR_REQ, &req_val);
+
+ req_val &= ~BIT(req);
+
+ regmap_write(aspeed_regmap, ASPEED_MCR_REQ, req_val);
+}
+EXPORT_SYMBOL(aspeed_sdmc_disable_mem_protection);
+
+static const u32 ast2400_dram_table[] = {
+ 64 << 20,
+ 128 << 20,
+ 256 << 20,
+ 512 << 20,
+};
+
+static const u32 ast2500_dram_table[] = {
+ 128 << 20,
+ 256 << 20,
+ 512 << 20,
+ 1024 << 20,
+};
+
+static const u32 ast2600_dram_table[] = {
+ 256 << 20,
+ 512 << 20,
+ 1024 << 20,
+ 2048 << 20,
+};
+
+extern u32 aspeed_get_dram_size(void)
+{
+ u32 reg04;
+ u32 size;
+ u8 type;
+
+ regmap_read(aspeed_regmap, ASPEED_MCR_CONF, ®04);
+
+ type = (reg04 & ASPEED_MCR_CONF_DRAM_CTRL_TYPE) >> 28;
+
+ if (type == ASPEED_MCR_CONF_DRAM_CTRL_TYPE_AST2600)
+ size = ast2600_dram_table[reg04 & 0x3];
+ else if (type == ASPEED_MCR_CONF_DRAM_CTRL_TYPE_AST2500)
+ size = ast2500_dram_table[reg04 & 0x3];
+ else
+ size = ast2400_dram_table[reg04 & 0x3];
+
+ return size;
+}
+EXPORT_SYMBOL(aspeed_get_dram_size);
+
+static const u32 aspeed_vga_table[] = {
+ 8 << 20,
+ 16 << 20,
+ 32 << 20,
+ 64 << 20,
+};
+
+extern u32 aspeed_get_vga_size(void)
+{
+ u32 reg04;
+ u32 size;
+
+ regmap_read(aspeed_regmap, ASPEED_MCR_CONF, ®04);
+
+ size = aspeed_vga_table[((reg04 & 0xC) >> 2)];
+ return size;
+}
+EXPORT_SYMBOL(aspeed_get_vga_size);
+
static bool regmap_is_volatile(struct device *dev, unsigned int reg)
{
switch (reg) {
@@ -227,7 +300,6 @@ static int config_irq(void *ctx, struct platform_device *pdev)
return 0;
}
-
static int init_csrows(struct mem_ctl_info *mci)
{
struct csrow_info *csrow = mci->csrows[0];
@@ -239,7 +311,7 @@ static int init_csrows(struct mem_ctl_info *mci)
int rc;
/* retrieve info about physical memory from device tree */
- np = of_find_node_by_path("/memory");
+ np = of_find_node_by_name(NULL, "memory");
if (!np) {
dev_err(mci->pdev, "dt: missing /memory node\n");
return -ENODEV;
@@ -275,14 +347,12 @@ static int init_csrows(struct mem_ctl_info *mci)
return 0;
}
-
static int aspeed_probe(struct platform_device *pdev)
{
struct device *dev = &pdev->dev;
struct edac_mc_layer layers[2];
struct mem_ctl_info *mci;
void __iomem *regs;
- u32 reg04;
int rc;
regs = devm_platform_ioremap_resource(pdev, 0);
@@ -294,13 +364,6 @@ static int aspeed_probe(struct platform_device *pdev)
if (IS_ERR(aspeed_regmap))
return PTR_ERR(aspeed_regmap);
- /* bail out if ECC mode is not configured */
- regmap_read(aspeed_regmap, ASPEED_MCR_CONF, ®04);
- if (!(reg04 & ASPEED_MCR_CONF_ECC)) {
- dev_err(&pdev->dev, "ECC mode is not configured in u-boot\n");
- return -EPERM;
- }
-
edac_op_state = EDAC_OPSTATE_INT;
/* allocate & init EDAC MC data structure */
@@ -373,12 +436,13 @@ static int aspeed_remove(struct platform_device *pdev)
return 0;
}
-
static const struct of_device_id aspeed_of_match[] = {
+ { .compatible = "aspeed,ast2400-sdram-edac" },
{ .compatible = "aspeed,ast2500-sdram-edac" },
+ { .compatible = "aspeed,ast2600-sdram-edac" },
{},
};
-
+MODULE_DEVICE_TABLE(of, aspeed_of_match);
static struct platform_driver aspeed_driver = {
.driver = {
@@ -395,18 +459,15 @@ static int __init aspeed_init(void)
return platform_driver_register(&aspeed_driver);
}
-
static void __exit aspeed_exit(void)
{
platform_driver_unregister(&aspeed_driver);
}
-
module_init(aspeed_init);
module_exit(aspeed_exit);
-
MODULE_LICENSE("GPL");
MODULE_AUTHOR("Stefan Schaeckeler <sschaeck at cisco.com>");
-MODULE_DESCRIPTION("Aspeed AST2500 EDAC driver");
+MODULE_DESCRIPTION("Aspeed EDAC driver");
MODULE_VERSION("1.0");
--
2.17.1
More information about the linux-arm-kernel
mailing list