[PATCH 26/33] ARM: dts: exynos: Override thermal by label in Midas

[Krzysztof Kozlowski]

Using full paths to extend or override a device tree node is error prone
since if there was a typo error, a new node will be created instead of
extending the node as it was desired.  This will lead to run-time errors
that could be hard to detect.

A mistyped label on the other hand, will cause a dtc compile error
(during build time).

Signed-off-by: Krzysztof Kozlowski <krzk at kernel.org>
---
 arch/arm/boot/dts/exynos4412-midas.dtsi | 34 +++++++++++--------------
 1 file changed, 15 insertions(+), 19 deletions(-)

diff --git a/arch/arm/boot/dts/exynos4412-midas.dtsi b/arch/arm/boot/dts/exynos4412-midas.dtsi
index 32d2e539b2dd..7e7c243ff196 100644
--- a/arch/arm/boot/dts/exynos4412-midas.dtsi
+++ b/arch/arm/boot/dts/exynos4412-midas.dtsi
@@ -319,25 +319,6 @@
 		pulldown-ohm = <100000>; /* 100K */
 		io-channels = <&adc 2>;  /* Battery temperature */
 	};
-
-	thermal-zones {
-		cpu_thermal: cpu-thermal {
-			cooling-maps {
-				map0 {
-				     /* Corresponds to 800MHz at freq_table */
-				     cooling-device = <&cpu0 7 7>, <&cpu1 7 7>,
-						      <&cpu2 7 7>, <&cpu3 7 7>;
-				};
-				map1 {
-				     /* Corresponds to 200MHz at freq_table */
-				     cooling-device = <&cpu0 13 13>,
-						      <&cpu1 13 13>,
-						      <&cpu2 13 13>,
-						      <&cpu3 13 13>;
-			       };
-		       };
-		};
-	};
 };
 
 &adc {
@@ -406,6 +387,21 @@
 	cpu0-supply = <&buck2_reg>;
 };
 
+&cpu_thermal {
+	cooling-maps {
+		map0 {
+			/* Corresponds to 800MHz at freq_table */
+			cooling-device = <&cpu0 7 7>, <&cpu1 7 7>,
+					 <&cpu2 7 7>, <&cpu3 7 7>;
+		};
+		map1 {
+			/* Corresponds to 200MHz at freq_table */
+			cooling-device = <&cpu0 13 13>, <&cpu1 13 13>,
+					 <&cpu2 13 13>, <&cpu3 13 13>;
+		};
+	};
+};
+
 &csis_0 {
 	status = "okay";
 	vddcore-supply = <&ldo8_reg>;
-- 
2.17.1