[PATCH] ARM: dts: stm32: Swap PHY reset GPIO and TSC2004 IRQ

[Alexandre Torgue]

Hi Marek

On 8/22/20 10:33 PM, Marek Vasut wrote:
> On the production revision of the SoM, 587-200, the PHY reset GPIO and
> touchscreen IRQs are swapped to prevent collision between EXTi IRQs,
> reflect that in DT.
> 
> Fixes: 34e0c7847dcf ("ARM: dts: stm32: Add DH Electronics DHCOM STM32MP1 SoM and PDK2 board")
> Signed-off-by: Marek Vasut <marex at denx.de>

Applied on stm32-next. I updated a bit this patch as now the ethernet0 
node is located in stm32mp15xx-dhcom-som.dtsi.


Thanks.
Alex

> Cc: Alexandre Torgue <alexandre.torgue at st.com>
> Cc: Maxime Coquelin <mcoquelin.stm32 at gmail.com>
> Cc: Patrice Chotard <patrice.chotard at st.com>
> Cc: Patrick Delaunay <patrick.delaunay at st.com>
> Cc: linux-stm32 at st-md-mailman.stormreply.com
> To: linux-arm-kernel at lists.infradead.org
> ---
>   arch/arm/boot/dts/stm32mp15xx-dhcom-pdk2.dtsi | 2 +-
>   arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi  | 2 +-
>   2 files changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/arch/arm/boot/dts/stm32mp15xx-dhcom-pdk2.dtsi b/arch/arm/boot/dts/stm32mp15xx-dhcom-pdk2.dtsi
> index 075e2a95713f..e31841d71e8b 100644
> --- a/arch/arm/boot/dts/stm32mp15xx-dhcom-pdk2.dtsi
> +++ b/arch/arm/boot/dts/stm32mp15xx-dhcom-pdk2.dtsi
> @@ -150,7 +150,7 @@ &ethernet0 {
>   	max-speed = <100>;
>   	phy-handle = <&phy0>;
>   	st,eth-ref-clk-sel;
> -	phy-reset-gpios = <&gpioh 15 GPIO_ACTIVE_LOW>;
> +	phy-reset-gpios = <&gpioh 3 GPIO_ACTIVE_LOW>;
>   
>   	mdio0 {
>   		#address-cells = <1>;
> diff --git a/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi b/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi
> index ba905196fb54..43f5e8498d7b 100644
> --- a/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi
> +++ b/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi
> @@ -249,7 +249,7 @@ touchscreen at 49 {
>   		compatible = "ti,tsc2004";
>   		reg = <0x49>;
>   		vio-supply = <&v3v3>;
> -		interrupts-extended = <&gpioh 3 IRQ_TYPE_EDGE_FALLING>;
> +		interrupts-extended = <&gpioh 15 IRQ_TYPE_EDGE_FALLING>;
>   	};
>   
>   	eeprom at 50 {
>