[PATCH v2 0/6] ARM: BCM5301X: add Meraki MR32 series

[Florian Fainelli]

On 8/22/2020 9:19 AM, Christian Lamparter wrote:
> Hello,
> 
> I've been holding on to this devices dts' for a while now.
> But since the HW has been running with versions of these
> patches for more than a year, I do think I should make it
> available in upstream in order to move on.
> 
> Hardware-Info of the Meraki MR32:
> 
> This is a dual-band enterprise class 802.11ac access point.
> The unit was donated by Chris Blake. Thank you!
>      
> SoC:    Broadcom BCM53016A1 (1 GHz, 2 cores)
> RAM:    128 MiB
> NAND:   128 MiB Spansion S34ML01G2 (~114 MiB useable)
> ETH:    1GBit Ethernet Port - PoE
> WIFI1:  Broadcom BCM43520 an+ac (2x2:2 - id: 0x4352)
> WIFI2:  Broadcom BCM43520 bgn (2x2:2 - id: 0x4352)
> WIFI3:  Broadcom BCM43428 abgn (1x1:1 - id: 43428)
> 
> So far, the remaining TODOs center around the pinctrl,
> i2c and WIFI. The I2C is implemented with the bit-banged
> i2c-gpio driver as the SoC's I2C didn't budge after
> many hours of trying.
> 
> A patch that included the "meraki" vendor-prefix has
> been broken out of the series as recommended by
> Florian Fainelli. Here's the link:
> <https://lists.ozlabs.org/pipermail/linuxppc-dev/2020-August/216949.html>

Series applied, thanks Christian, let's work separately on the pinctrl 
driver and using the hardware i2c controller. Thanks
-- 
Florian