[v4,2/4] dt-binding: reset-controller: ti: add 'mediatek,infra-reset' to compatible

[Crystal Guo]

On Wed, 2020-08-26 at 03:02 +0800, Rob Herring wrote:
> On Mon, Aug 17, 2020 at 11:03:22AM +0800, Crystal Guo wrote:
> > The TI syscon reset controller provides a common reset management,
> > and is suitable for MTK SoCs. Add compatible 'mediatek,infra-reset',
> > which denotes to use ti reset-controller driver directly.
> > 
> > Signed-off-by: Crystal Guo <crystal.guo at mediatek.com>
> > ---
> >  Documentation/devicetree/bindings/reset/ti-syscon-reset.txt | 1 +
> >  1 file changed, 1 insertion(+)
> > 
> > diff --git a/Documentation/devicetree/bindings/reset/ti-syscon-reset.txt b/Documentation/devicetree/bindings/reset/ti-syscon-reset.txt
> > index ab041032339b..5a0e9365b51b 100644
> > --- a/Documentation/devicetree/bindings/reset/ti-syscon-reset.txt
> > +++ b/Documentation/devicetree/bindings/reset/ti-syscon-reset.txt
> > @@ -25,6 +25,7 @@ Required properties:
> >  			    "ti,k2l-pscrst"
> >  			    "ti,k2hk-pscrst"
> >  			    "ti,syscon-reset"
> > +			    "mediatek,infra-reset", "ti,syscon-reset"
> 
> You need your own binding doc. If you can use the same driver then fine, 
> but that's a separate issue. There's also reset-simple driver if you 
> have just array of 32-bit registers with a bit per reset.
> 
> Don't repeat 'ti,reset-bits' either.

Do you mean I should add a Mediatek reset binding doc, although Mediatek
reuse the TI reset controller directly?

Best Regards
Crystal
> 
> >   - #reset-cells		: Should be 1. Please see the reset consumer node below
> >  			  for usage details
> >   - ti,reset-bits	: Contains the reset control register information
> > -- 
> > 2.18.0