[v4, 1/4] dt-binding: reset-controller: ti: add reset-duration-us property

[Rob Herring]

On Mon, Aug 17, 2020 at 11:03:21AM +0800, Crystal Guo wrote:
> introduce 'reset' method to allow device do serialized assert and
> deassert operations in a single step, which needs a minimum delay
> to be waited between assert and deassert.

Why is Mediatek adding to a TI binding?

> 
> Signed-off-by: Crystal Guo <crystal.guo at mediatek.com>
> ---
>  Documentation/devicetree/bindings/reset/ti-syscon-reset.txt | 5 +++++
>  1 file changed, 5 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/reset/ti-syscon-reset.txt b/Documentation/devicetree/bindings/reset/ti-syscon-reset.txt
> index 86945502ccb5..ab041032339b 100644
> --- a/Documentation/devicetree/bindings/reset/ti-syscon-reset.txt
> +++ b/Documentation/devicetree/bindings/reset/ti-syscon-reset.txt
> @@ -59,6 +59,11 @@ Required properties:
>  Please also refer to Documentation/devicetree/bindings/reset/reset.txt for
>  common reset controller usage by consumers.
>  
> +Optional properties:
> +- reset-duration-us: When do serialized assert and deassert operations, minimum delay in microseconds
> +is needed to be waited between an assert and a deassert to reset the device. This value can be 0, 0 means
> +that such a delay is not needed.

This goes in the reset controller node or each consumer? For the latter, 
it should be a cell in 'resets' if you need this. But really, I think 
the reset controller should enforce some minimum time that works for all 
consumers. Surely having a minimum time per reset isn't really needed.

Rob