[PATCH 2/3] ARM: dts: Add ethernet

[Łukasz Stelmach]

Add node for ax88796c ethernet chip.

Signed-off-by: Łukasz Stelmach <l.stelmach at samsung.com>
---
 arch/arm/boot/dts/exynos3250-artik5-eval.dts | 21 ++++++++++++++++++++
 1 file changed, 21 insertions(+)

diff --git a/arch/arm/boot/dts/exynos3250-artik5-eval.dts b/arch/arm/boot/dts/exynos3250-artik5-eval.dts
index 20446a846a98..44151a2cb35d 100644
--- a/arch/arm/boot/dts/exynos3250-artik5-eval.dts
+++ b/arch/arm/boot/dts/exynos3250-artik5-eval.dts
@@ -37,3 +37,24 @@ &mshc_2 {
 &serial_2 {
 	status = "okay";
 };
+
+&spi_0 {
+		status = "okay";
+		cs-gpios = <&gpx3 4 GPIO_ACTIVE_LOW>, <0>;
+
+		assigned-clocks        = <&cmu CLK_MOUT_MPLL>, <&cmu CLK_DIV_MPLL_PRE>, <&cmu CLK_MOUT_SPI0>,    <&cmu CLK_DIV_SPI0>,  <&cmu CLK_DIV_SPI0_PRE>, <&cmu CLK_SCLK_SPI0>;
+		assigned-clock-parents = <&cmu CLK_FOUT_MPLL>, <&cmu CLK_MOUT_MPLL>,    <&cmu CLK_DIV_MPLL_PRE>, <&cmu CLK_MOUT_SPI0>, <&cmu CLK_DIV_SPI0>,     <&cmu CLK_DIV_SPI0_PRE>;
+
+		ax88796c at 0 {
+			compatible = "asix,ax88796c";
+			interrupt-parent = <&gpx2>;
+			interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
+			spi-max-frequency = <40000000>;
+			reg = <0x0>;
+			reset-gpios = <&gpe0 2 GPIO_ACTIVE_LOW>;
+			controller-data {
+				samsung,spi-feedback-delay = <2>;
+				samsung,spi-chip-select-mode;
+		};
+	};
+};
-- 
2.26.2