[PATCH 1/5] arm64: dts: imx8mm-evk: Replace deprecated phy reset properties

[Krzysztof Kozlowski]

Use preferred properties of phy node instead of deprecated
phy-reset-gpios (and others).  This avoids copying deprecated code into
future DTSes.

Signed-off-by: Krzysztof Kozlowski <krzk at kernel.org>

---

Not tested on HW.
---
 arch/arm64/boot/dts/freescale/imx8mm-evk.dts | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx8mm-evk.dts b/arch/arm64/boot/dts/freescale/imx8mm-evk.dts
index 19a22d0d0730..c1f7d44651df 100644
--- a/arch/arm64/boot/dts/freescale/imx8mm-evk.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mm-evk.dts
@@ -119,8 +119,6 @@
 	pinctrl-0 = <&pinctrl_fec1>;
 	phy-mode = "rgmii-id";
 	phy-handle = <&ethphy0>;
-	phy-reset-gpios = <&gpio4 22 GPIO_ACTIVE_LOW>;
-	phy-reset-duration = <10>;
 	fsl,magic-packet;
 	status = "okay";
 
@@ -131,6 +129,8 @@
 		ethphy0: ethernet-phy at 0 {
 			compatible = "ethernet-phy-ieee802.3-c22";
 			reg = <0>;
+			reset-gpios = <&gpio4 22 GPIO_ACTIVE_LOW>;
+			reset-assert-us = <10000>;
 		};
 	};
 };
-- 
2.17.1