[PATCH v6 5/6] PCI: uniphier: Add iATU register support

Kunihiko Hayashi hayashi.kunihiko at socionext.com
Fri Aug 21 03:05:16 EDT 2020


On 2020/08/18 1:48, Rob Herring wrote:
> On Fri, Aug 7, 2020 at 4:25 AM Kunihiko Hayashi
> <hayashi.kunihiko at socionext.com> wrote:
>>
>> This gets iATU register area from reg property. In Synopsys DWC version
>> 4.80 or later, since iATU register area is separated from core register
>> area, this area is necessary to get from DT independently.
>>
>> Signed-off-by: Kunihiko Hayashi <hayashi.kunihiko at socionext.com>
>> ---
>>   drivers/pci/controller/dwc/pcie-uniphier.c | 5 +++++
>>   1 file changed, 5 insertions(+)
>>
>> diff --git a/drivers/pci/controller/dwc/pcie-uniphier.c b/drivers/pci/controller/dwc/pcie-uniphier.c
>> index 55a7166..93ef608 100644
>> --- a/drivers/pci/controller/dwc/pcie-uniphier.c
>> +++ b/drivers/pci/controller/dwc/pcie-uniphier.c
>> @@ -471,6 +471,11 @@ static int uniphier_pcie_probe(struct platform_device *pdev)
>>          if (IS_ERR(priv->pci.dbi_base))
>>                  return PTR_ERR(priv->pci.dbi_base);
>>
>> +       priv->pci.atu_base =
>> +               devm_platform_ioremap_resource_byname(pdev, "atu");
>> +       if (IS_ERR(priv->pci.atu_base))
>> +               priv->pci.atu_base = NULL;
> 
> Keystone has the same 'atu' resource setup. Please move its code to
> the DW core and use that.

There are some platforms that pci.atu_base is set by other way.
The 'atu' code shouldn't be conflicted with the following existing code.

   drivers/pci/controller/dwc/pci-keystone.c:              atu_base = devm_platform_ioremap_resource_byname(pdev, "atu");
   drivers/pci/controller/dwc/pci-keystone.c:              pci->atu_base = atu_base;
   drivers/pci/controller/dwc/pcie-designware.c:                   pci->atu_base = pci->dbi_base + DEFAULT_DBI_ATU_OFFSET;
   drivers/pci/controller/dwc/pcie-intel-gw.c:     pci->atu_base = pci->dbi_base + data->pcie_atu_offset;
   drivers/pci/controller/dwc/pcie-tegra194.c:     pci->atu_base = devm_ioremap_resource(dev, atu_dma_res);

So I'm not sure where to move the code in the DW core.
Is there any idea?

Thank you,

---
Best Regards
Kunihiko Hayashi



More information about the linux-arm-kernel mailing list