[PATCH v2 1/4] dt-bindings: media: csi2dc: add bindings for microchip csi2dc

[Eugen.Hristev at microchip.com]

On 14.08.2020 01:46, Sakari Ailus wrote:
> Hi Eugen,
> 
> On Fri, Jul 03, 2020 at 10:44:13AM +0300, Eugen Hristev wrote:
>> Add bindings documentation for microchip CSI2 Demultiplexer controller.
> 
> ...
> 
>> +  port at 1:
>> +    type: object
>> +    description:
>> +      Output port node, single endpoint, describing the output pad.
>> +
>> +    properties:
>> +      '#address-cells':
>> +        const: 1
>> +
>> +      '#size-cells':
>> +        const: 0
>> +
>> +      reg:
>> +        const: 1
>> +
>> +    patternProperties:
>> +      "^endpoint@[0-9a-f]$":
>> +        type: object
>> +
>> +        properties:
>> +          reg:
>> +            enum: [0, 1, 2, 3]
>> +            description: virtual channel for the endpoint
> 
> Unless you need this right now I'd just hard code this to zero in the
> driver. You can't have more endpoints for active devices anyway, can you?

Hello Sakari,

You are right, but, the virtual ID must be written in hardware 
registers. So I can take the virtual ID from this property.
Otherwise, if I hardcode this in the driver, another virtual ID would be 
impossible to use without changing the driver. And if the binding is 
accepted without this property, it will be 'set in stone' and difficult 
to change afterwards.

What do you think ?

Eugen
> 
> --
> Sakari Ailus
>