[PATCH 02/18] spi: stm32-spi: defer probe for reset

[Alain Volmat]

On Wed, Aug 05, 2020 at 11:49:06AM +0100, Mark Brown wrote:
> On Wed, Aug 05, 2020 at 09:01:57AM +0200, Alain Volmat wrote:
> 
> > -	rst = devm_reset_control_get_exclusive(&pdev->dev, NULL);
> > -	if (!IS_ERR(rst)) {
> > +	rst = devm_reset_control_get_optional_exclusive(&pdev->dev, NULL);
> > +	if (rst) {
> > +		if (IS_ERR(rst)) {
> > +			ret = PTR_ERR(rst);
> > +			if (ret != -EPROBE_DEFER)
> > +				dev_err(&pdev->dev, "reset get failed: %d\n",
> > +					ret);
> > +			goto err_clk_disable;
> > +		}
> 
> This will not provide any diagnostics when deferring which isn't very
> helpful if there's issues.

Do you mean that a message when deferring would be needed ?

I am worrying that this would lead to having too much noise during boot
since probe deferring is kinda common. Of course it can also be due to a bad
configuration of the kernel as well but having looked around I think that
usually driver are rather silent in case of deferring.