[PATCHv3 5/7] ARM: dts: exynos5422: use wp-gpio method to detect sd-card

Anand Moon linux.amoon at gmail.com
Sat Sep 22 00:55:15 PDT 2018


Hi Krzysztof,
On Sat, 22 Sep 2018 at 02:39, Krzysztof Kozlowski <krzk at kernel.org> wrote:
>
> On Fri, Sep 21, 2018 at 06:01:07PM +0530, Anand Moon wrote:
> > Hi Krzysztof,
> >
> > On Fri, 21 Sep 2018 at 16:42, Krzysztof Kozlowski <krzk at kernel.org> wrote:
> > >
> > > On Thu, 20 Sep 2018 at 19:59, Anand Moon <linux.amoon at gmail.com> wrote:
> > > >
> > > > add the Write Protect GPIO property for sdcard, to fix
> > > > the warning message during boot time.
> > > > of_get_named_gpiod_flags: can't parse 'wp-gpios' property of node '/soc/mmc at 12220000[0]'
> > > >
> > > > Signed-off-by: Anand Moon <linux.amoon at gmail.com>
> > > > ---
> > > > New patch to this series.
> > > > If we keep the wp-gpio GPIO_ACTIVE_LOW sdcard boot into RO mode.
> > > > ---
> > > >  arch/arm/boot/dts/exynos5422-odroid-core.dtsi | 1 +
> > > >  1 file changed, 1 insertion(+)
> > > >
> > > > diff --git a/arch/arm/boot/dts/exynos5422-odroid-core.dtsi b/arch/arm/boot/dts/exynos5422-odroid-core.dtsi
> > > > index 03fe02ceae66..475c38bbc99e 100644
> > > > --- a/arch/arm/boot/dts/exynos5422-odroid-core.dtsi
> > > > +++ b/arch/arm/boot/dts/exynos5422-odroid-core.dtsi
> > > > @@ -370,6 +370,7 @@
> > > >         cap-sd-highspeed;
> > > >         max-frequency = <200000000>;
> > > >         cd-gpios = <&gpc2 2 GPIO_ACTIVE_LOW>;
> > > > +       wp-gpios = <&gpc4 0 GPIO_ACTIVE_HIGH>;
> > >
> > > Two issues here:
> > > 1. You need also proper pinctrl setting.
> >
> > Thanks for pointing out. Yes proper pinctrl is needed to support this setting.
> > probably pinctrl sd2_wp is needed to support this feature.
> >
> > > 2. On schematics the WP is not connected... so how do you know that it
> > From XU4_MAIN_REV0.1 schematics page 7 "Micro Socket" their is no
> > connection to WP pin.
> > but below schematics page "EXYNOS 5422 MMC UFS" it's shows
> > XMMC2WP/GPC4_0/EXT_INT13_0.
> >
> > > is active high? How did you test it? How do you want to test it on
> > > microSD?
> >
> > I just tested this with the DTS change to GPIO_ACTIVE_LOW which
> > resulted the microSD card booted into RO mode.
> > So I set this to GPIO_ACTIVE_HIGH just to avoid warning.
> >
> > I will study the changes requires and then post proper separate patch
> > to support this feature.
>
> Please squash it with cd-gpios change and send it only for the purpose
> of describing the hardware. They do not have any meaningful change from
> functional point of view (maybe except slower code as now it goes
> through gpio subsystem instead of just reading dw-mmc registers).
>
> Please use full sentences in commit msg (so start with capital letter)
> and remove reference for warning because there is no warning.
> You can follow up on my change for XU:
> https://patchwork.kernel.org/patch/10610985/
>
Ok I have tried to squash the changes into single patch.

> Best regards,
> Krzysztof

Best Regards
-Anand



More information about the linux-arm-kernel mailing list