[PATCH net-next v3 05/10] net: mvpp2: 1000baseX support
Antoine Tenart
antoine.tenart at bootlin.com
Thu May 17 01:29:34 PDT 2018
This patch adds the 1000Base-X PHY mode support in the Marvell PPv2
driver. 1000Base-X is quite close the SGMII and uses nearly the same
code path.
Signed-off-by: Antoine Tenart <antoine.tenart at bootlin.com>
---
drivers/net/ethernet/marvell/mvpp2.c | 72 ++++++++++++++++++++--------
1 file changed, 51 insertions(+), 21 deletions(-)
diff --git a/drivers/net/ethernet/marvell/mvpp2.c b/drivers/net/ethernet/marvell/mvpp2.c
index 60093f1e6297..ece61f1727e4 100644
--- a/drivers/net/ethernet/marvell/mvpp2.c
+++ b/drivers/net/ethernet/marvell/mvpp2.c
@@ -4870,6 +4870,7 @@ static int mvpp22_gop_init(struct mvpp2_port *port)
mvpp22_gop_init_rgmii(port);
break;
case PHY_INTERFACE_MODE_SGMII:
+ case PHY_INTERFACE_MODE_1000BASEX:
mvpp22_gop_init_sgmii(port);
break;
case PHY_INTERFACE_MODE_10GKR:
@@ -4907,7 +4908,8 @@ static void mvpp22_gop_unmask_irq(struct mvpp2_port *port)
u32 val;
if (phy_interface_mode_is_rgmii(port->phy_interface) ||
- port->phy_interface == PHY_INTERFACE_MODE_SGMII) {
+ port->phy_interface == PHY_INTERFACE_MODE_SGMII ||
+ port->phy_interface == PHY_INTERFACE_MODE_1000BASEX) {
/* Enable the GMAC link status irq for this port */
val = readl(port->base + MVPP22_GMAC_INT_SUM_MASK);
val |= MVPP22_GMAC_INT_SUM_MASK_LINK_STAT;
@@ -4937,7 +4939,8 @@ static void mvpp22_gop_mask_irq(struct mvpp2_port *port)
}
if (phy_interface_mode_is_rgmii(port->phy_interface) ||
- port->phy_interface == PHY_INTERFACE_MODE_SGMII) {
+ port->phy_interface == PHY_INTERFACE_MODE_SGMII ||
+ port->phy_interface == PHY_INTERFACE_MODE_1000BASEX) {
val = readl(port->base + MVPP22_GMAC_INT_SUM_MASK);
val &= ~MVPP22_GMAC_INT_SUM_MASK_LINK_STAT;
writel(val, port->base + MVPP22_GMAC_INT_SUM_MASK);
@@ -4949,7 +4952,8 @@ static void mvpp22_gop_setup_irq(struct mvpp2_port *port)
u32 val;
if (phy_interface_mode_is_rgmii(port->phy_interface) ||
- port->phy_interface == PHY_INTERFACE_MODE_SGMII) {
+ port->phy_interface == PHY_INTERFACE_MODE_SGMII ||
+ port->phy_interface == PHY_INTERFACE_MODE_1000BASEX) {
val = readl(port->base + MVPP22_GMAC_INT_MASK);
val |= MVPP22_GMAC_INT_MASK_LINK_STAT;
writel(val, port->base + MVPP22_GMAC_INT_MASK);
@@ -4974,6 +4978,7 @@ static int mvpp22_comphy_init(struct mvpp2_port *port)
switch (port->phy_interface) {
case PHY_INTERFACE_MODE_SGMII:
+ case PHY_INTERFACE_MODE_1000BASEX:
mode = PHY_MODE_SGMII;
break;
case PHY_INTERFACE_MODE_10GKR:
@@ -5056,7 +5061,8 @@ static void mvpp2_port_loopback_set(struct mvpp2_port *port,
else
val &= ~MVPP2_GMAC_GMII_LB_EN_MASK;
- if (port->phy_interface == PHY_INTERFACE_MODE_SGMII)
+ if (port->phy_interface == PHY_INTERFACE_MODE_SGMII ||
+ port->phy_interface == PHY_INTERFACE_MODE_1000BASEX)
val |= MVPP2_GMAC_PCS_LB_EN_MASK;
else
val &= ~MVPP2_GMAC_PCS_LB_EN_MASK;
@@ -6266,7 +6272,8 @@ static irqreturn_t mvpp2_link_status_isr(int irq, void *dev_id)
link = true;
}
} else if (phy_interface_mode_is_rgmii(port->phy_interface) ||
- port->phy_interface == PHY_INTERFACE_MODE_SGMII) {
+ port->phy_interface == PHY_INTERFACE_MODE_SGMII ||
+ port->phy_interface == PHY_INTERFACE_MODE_1000BASEX) {
val = readl(port->base + MVPP22_GMAC_INT_STAT);
if (val & MVPP22_GMAC_INT_STAT_LINK) {
event = true;
@@ -8032,20 +8039,25 @@ static void mvpp2_phylink_validate(struct net_device *dev,
phylink_set(mask, Pause);
phylink_set(mask, Asym_Pause);
- phylink_set(mask, 10baseT_Half);
- phylink_set(mask, 10baseT_Full);
- phylink_set(mask, 100baseT_Half);
- phylink_set(mask, 100baseT_Full);
- phylink_set(mask, 1000baseT_Full);
- phylink_set(mask, 10000baseT_Full);
-
- if (state->interface == PHY_INTERFACE_MODE_10GKR) {
+ switch (state->interface) {
+ case PHY_INTERFACE_MODE_10GKR:
phylink_set(mask, 10000baseCR_Full);
phylink_set(mask, 10000baseSR_Full);
phylink_set(mask, 10000baseLR_Full);
phylink_set(mask, 10000baseLRM_Full);
phylink_set(mask, 10000baseER_Full);
phylink_set(mask, 10000baseKR_Full);
+ /* Fall-through */
+ default:
+ phylink_set(mask, 10baseT_Half);
+ phylink_set(mask, 10baseT_Full);
+ phylink_set(mask, 100baseT_Half);
+ phylink_set(mask, 100baseT_Full);
+ phylink_set(mask, 10000baseT_Full);
+ /* Fall-through */
+ case PHY_INTERFACE_MODE_1000BASEX:
+ phylink_set(mask, 1000baseT_Full);
+ phylink_set(mask, 1000baseX_Full);
}
bitmap_and(supported, supported, mask, __ETHTOOL_LINK_MODE_MASK_NBITS);
@@ -8084,12 +8096,18 @@ static void mvpp2_gmac_link_state(struct mvpp2_port *port,
state->link = !!(val & MVPP2_GMAC_STATUS0_LINK_UP);
state->duplex = !!(val & MVPP2_GMAC_STATUS0_FULL_DUPLEX);
- if (val & MVPP2_GMAC_STATUS0_GMII_SPEED)
+ switch (port->phy_interface) {
+ case PHY_INTERFACE_MODE_1000BASEX:
state->speed = SPEED_1000;
- else if (val & MVPP2_GMAC_STATUS0_MII_SPEED)
- state->speed = SPEED_100;
- else
- state->speed = SPEED_10;
+ break;
+ default:
+ if (val & MVPP2_GMAC_STATUS0_GMII_SPEED)
+ state->speed = SPEED_1000;
+ else if (val & MVPP2_GMAC_STATUS0_MII_SPEED)
+ state->speed = SPEED_100;
+ else
+ state->speed = SPEED_10;
+ }
state->pause = 0;
if (val & MVPP2_GMAC_STATUS0_RX_PAUSE)
@@ -8181,8 +8199,18 @@ static void mvpp2_gmac_config(struct mvpp2_port *port, unsigned int mode,
ctrl0 &= ~MVPP2_GMAC_PORT_TYPE_MASK;
ctrl2 &= ~(MVPP2_GMAC_PORT_RESET_MASK | MVPP2_GMAC_PCS_ENABLE_MASK);
- if (!phy_interface_mode_is_rgmii(state->interface))
+ if (state->interface == PHY_INTERFACE_MODE_1000BASEX) {
+ /* 1000BaseX port cannot negotiate speed nor can it negotiate
+ * duplex: they are always operating with a fixed speed of
+ * 1000Mbps in full duplex, so force 1000 speed and full duplex
+ * here.
+ */
+ ctrl0 |= MVPP2_GMAC_PORT_TYPE_MASK;
+ an |= MVPP2_GMAC_CONFIG_GMII_SPEED |
+ MVPP2_GMAC_CONFIG_FULL_DUPLEX;
+ } else if (!phy_interface_mode_is_rgmii(state->interface)) {
an |= MVPP2_GMAC_AN_SPEED_EN | MVPP2_GMAC_FLOW_CTRL_AUTONEG;
+ }
if (state->duplex)
an |= MVPP2_GMAC_CONFIG_FULL_DUPLEX;
@@ -8191,7 +8219,8 @@ static void mvpp2_gmac_config(struct mvpp2_port *port, unsigned int mode,
if (phylink_test(state->advertising, Asym_Pause))
an |= MVPP2_GMAC_FC_ADV_ASM_EN;
- if (state->interface == PHY_INTERFACE_MODE_SGMII) {
+ if (state->interface == PHY_INTERFACE_MODE_SGMII ||
+ state->interface == PHY_INTERFACE_MODE_1000BASEX) {
an |= MVPP2_GMAC_IN_BAND_AUTONEG;
ctrl2 |= MVPP2_GMAC_INBAND_AN_MASK | MVPP2_GMAC_PCS_ENABLE_MASK;
@@ -8256,7 +8285,8 @@ static void mvpp2_mac_config(struct net_device *dev, unsigned int mode,
if (state->interface == PHY_INTERFACE_MODE_10GKR)
mvpp2_xlg_config(port, mode, state);
else if (phy_interface_mode_is_rgmii(state->interface) ||
- state->interface == PHY_INTERFACE_MODE_SGMII)
+ state->interface == PHY_INTERFACE_MODE_SGMII ||
+ state->interface == PHY_INTERFACE_MODE_1000BASEX)
mvpp2_gmac_config(port, mode, state);
if (port->priv->hw_version == MVPP21 && port->flags & MVPP2_F_LOOPBACK)
--
2.17.0
More information about the linux-arm-kernel
mailing list