[PATCH 1/5] dt-bindings: pinctrl: document the STMFX pinctrl bindings

[Lee Jones]

On Wed, 16 May 2018, Amelie DELAUNAY wrote:

> 
> 
> On 05/16/2018 04:20 PM, Linus Walleij wrote:
> > On Wed, May 9, 2018 at 9:56 AM, Amelie DELAUNAY <amelie.delaunay at st.com> wrote:
> > 
> >> Indeed, stmfx has other functions than GPIO. But, after comments done
> >> here: [1] and there: [2], it has been decided to move MFD parent/GPIO
> >> child drivers into a single PINCTRL/GPIO driver because of the following
> >> reasons:
> >> - Other stmfx functions (IDD measurement and TouchScreen controller) are
> >> not used on any of the boards using an stmfx and supported by Linux, so
> >> no way to test these functions, and no need to maintain them while they
> >> are not being used.
> >> - But, in the case a new board will use more than GPIO function on
> >> stmfx, the actual implementation allow to easily extract common init
> >> part of stmfx and put it in an MFD driver.
> >>
> >> So I could remove gpio sub-node and put its contents in stmfx node and
> >> keep single PINCTRL/GPIO driver for the time being.
> >> Please advise,
> > 
> > I would normally advice to use the right modeling from the start, create
> > the MFD driver and spawn the devices from there. It is confusing
> > if the layout of the driver(s) doesn't really match the layout of the
> > hardware.
> > 
> > I understand that it is a pain to write new MFD drivers to get your
> > things going and it would be "nice to get this working really quick
> > now" but in my experience it is better to do it right from the start.
> > 
> 
> Hi Linus,
> 
> Thanks for your advice. I understand the point.
> So, the right modeling would be to:
> - create an MFD driver with the common init part of stmfx
> - remove all common init part of stmfx-pinctrl driver and keep only all 
> gpio/pinctrl functions.
> 
> I will not develop the other stmfx functions (IDD measurement driver and 
> TouchScreen controller driver) because, as explained ealier, they are 
> not used on any of the boards using an stmfx and supported by Linux, so 
> no way to test these functions, and no need to maintain them while they 
> are not being used.
> 
> Lee, are you OK with that ?

I missed a lot of this conversation I think, but from what I've read,
it sounds fine.

-- 
Lee Jones [李琼斯]
Linaro Services Technical Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog