[PATCH 1/6] dt-bindings: media: rcar-vin: Describe optional ep properties

[Jacopo Mondi]

Describe the optional endpoint properties for endpoint nodes of port at 0
and port at 1 of the R-Car VIN driver device tree bindings documentation.

Signed-off-by: Jacopo Mondi <jacopo+renesas at jmondi.org>
---
 Documentation/devicetree/bindings/media/rcar_vin.txt | 13 ++++++++++++-
 1 file changed, 12 insertions(+), 1 deletion(-)

diff --git a/Documentation/devicetree/bindings/media/rcar_vin.txt b/Documentation/devicetree/bindings/media/rcar_vin.txt
index a19517e1..c53ce4e 100644
--- a/Documentation/devicetree/bindings/media/rcar_vin.txt
+++ b/Documentation/devicetree/bindings/media/rcar_vin.txt
@@ -53,6 +53,16 @@ from local SoC CSI-2 receivers (port1) depending on SoC.
       from external SoC pins described in video-interfaces.txt[1].
       Describing more then one endpoint in port 0 is invalid. Only VIN
       instances that are connected to external pins should have port 0.
+
+      - Optional properties for endpoint nodes of port at 0:
+        - hsync-active: active state of the HSYNC signal, 0/1 for LOW/HIGH
+	  respectively. Default is active high.
+        - vsync-active: active state of the VSYNC signal, 0/1 for LOW/HIGH
+	  respectively. Default is active high.
+
+	If both HSYNC and VSYNC polarities are not specified, embedded
+	synchronization is selected.
+
     - port 1 - sub-nodes describing one or more endpoints connected to
       the VIN from local SoC CSI-2 receivers. The endpoint numbers must
       use the following schema.
@@ -62,6 +72,8 @@ from local SoC CSI-2 receivers (port1) depending on SoC.
         - Endpoint 2 - sub-node describing the endpoint connected to CSI40
         - Endpoint 3 - sub-node describing the endpoint connected to CSI41

+      Endpoint nodes of port at 1 do not support any optional endpoint property.
+
 Device node example for Gen2 platforms
 --------------------------------------

@@ -112,7 +124,6 @@ Board setup example for Gen2 platforms (vin1 composite video input)

                 vin1ep0: endpoint {
                         remote-endpoint = <&adv7180>;
-                        bus-width = <8>;
                 };
         };
 };
--
2.7.4