[PATCH V4] clk: at91: PLL recalc_rate() now using cached MUL and DIV values

[Stephen Boyd]

Quoting Marcin Ziemianowicz (2018-04-29 12:01:11)
> When a USB device is connected to the USB host port on the SAM9N12 then
> you get "-62" error which seems to indicate USB replies from the device
> are timing out. Based on a logic sniffer, I saw the USB bus was running
> at half speed.
> 
> The PLL code uses cached MUL and DIV values which get set in set_rate()
> and applied in prepare(), but the recalc_rate() function instead
> queries the hardware instead of using these cached values. Therefore,
> if recalc_rate() is called between a set_rate() and prepare(), the
> wrong frequency is calculated and later the USB clock divider for the
> SAM9N12 SOC will be configured for an incorrect clock.
> 
> In my case, the PLL hardware was set to 96 Mhz before the OHCI
> driver loads, and therefore the usb clock divider was being set
> to /2 even though the OHCI driver set the PLL to 48 Mhz.
> 
> As an alternative explanation, I noticed this was fixed in the past by
> 87e2ed338f1b ("clk: at91: fix recalc_rate implementation of PLL
> driver") but the bug was later re-introduced by 1bdf02326b71 ("clk:
> at91: make use of syscon/regmap internally").
> 
> Fixes: 1bdf02326b71 ("clk: at91: make use of syscon/regmap internally)
> Cc: <stable at vger.kernel.org>
> Signed-off-by: Marcin Ziemianowicz <marcin at ziemianowicz.com>
> ---

Applied to clk-next