[PATCHv2] arm64: dts: stratix10: Add QSPI support for Stratix10

[Thor Thayer]

On 05/15/2018 10:11 AM, Dinh Nguyen wrote:
> 
> On 05/11/2018 11:10 AM, thor.thayer at linux.intel.com wrote:
>> From: Thor Thayer <thor.thayer at linux.intel.com>
>>
>> Add qspi_clock
>>     The qspi_clk frequency is updated by U-Boot before starting Linux.
>> Add QSPI interface node.
>> Add QSPI flash memory child node.
>>     Setup the QSPI memory in 2 partitions.
>>
>> Signed-off-by: Thor Thayer <thor.thayer at linux.intel.com>
>> ---
>> v2  s/_/-/ in qspi-clk
>>      rename flash node.
>>      use partition child node notation<snip>>> +		qspi: spi at ff8d2000 {
>> +			compatible = "cdns,qspi-nor";
>> +			#address-cells = <1>;
>> +			#size-cells = <0>;
>> +			reg = <0xff8d2000 0x100>,
>> +			      <0xff900000 0x100000>;
>> +			interrupts = <0 3 4>;
>> +			cdns,fifo-depth = <128>;
>> +			cdns,fifo-width = <4>;
>> +			cdns,trigger-address = <0x00000000>;
>> +			clocks = <&qspi_clk>;
>> +			bus-num = <1>;
> 
> I don't you need "bus-num" anymore right? I don't see it getting used
> anywhere in the driver.
> 
> Dinh
> 

Yes, I missed that holdover. Thanks, I'll correct that.