[PATCH 1/2] ARM: dts: imx51-babbage: Fix USB PHY duplicate unit-address

[Shawn Guo]

On Mon, May 14, 2018 at 03:29:35PM -0300, Fabio Estevam wrote:
> From: Fabio Estevam <fabio.estevam at nxp.com>
> 
> Currently the following DTC warning is seen with W=1:
> 
> arch/arm/boot/dts/imx51-babbage.dtb: Warning (unique_unit_address): /usbphy/usbphy at 0: duplicate unit-address (also used in node /usbphy/usbh1phy at 0)
> 
> Fix it by moving the USB PHY node outside of simple-bus and drop the
> unneeded unit-address.
> 
> Signed-off-by: Fabio Estevam <fabio.estevam at nxp.com>
> ---
>  arch/arm/boot/dts/imx51-babbage.dts | 21 +++++++--------------
>  1 file changed, 7 insertions(+), 14 deletions(-)
> 
> diff --git a/arch/arm/boot/dts/imx51-babbage.dts b/arch/arm/boot/dts/imx51-babbage.dts
> index b8ca73d..de46906 100644
> --- a/arch/arm/boot/dts/imx51-babbage.dts
> +++ b/arch/arm/boot/dts/imx51-babbage.dts
> @@ -170,20 +170,13 @@
>  		mux-ext-port = <3>;
>  	};
>  
> -	usbphy {
> -		#address-cells = <1>;
> -		#size-cells = <0>;
> -		compatible = "simple-bus";
> -
> -		usbh1phy: usbh1phy at 0 {
> -			compatible = "usb-nop-xceiv";
> -			reg = <0>;
> -			clocks = <&clk_usb>;
> -			clock-names = "main_clk";
> -			reset-gpios = <&gpio2 5 GPIO_ACTIVE_LOW>;
> -			vcc-supply = <&vusb_reg>;
> -			#phy-cells = <0>;
> -		};
> +	usbh1phy: usbphy1 {
> +		compatible = "usb-nop-xceiv";
> +		clocks = <&clk_usb>;
> +		clock-names = "main_clk";
> +		reset-gpios = <&gpio2 5 GPIO_ACTIVE_LOW>;
> +		vcc-supply = <&vusb_reg>;
> +		#phy-cells = <0>;

This should be considered as a whole together with usbphy in imx51.dtsi.
Also, I would like to get some input from DT folks on how we should name
the node uniquely.  @Rob.

Shawn

>  	};
>  };
>  
> -- 
> 2.7.4
>