[RFC] ARM: dts: imx7s: Fix the port reg properties

[Fabio Estevam]

From: Fabio Estevam <fabio.estevam at nxp.com>

The 'reg' property must match the unit address, so fix them
to avoid the following DTC warnings with W=1:

arch/arm/boot/dts/imx7d-cl-som-imx7.dtb: Warning (graph_port): /replicator/ports/port at 2: graph node unit address error, expected "0"
arch/arm/boot/dts/imx7d-cl-som-imx7.dtb: Warning (graph_port): /soc/funnel at 30041000/ports/port at 2: graph node unit address error, expected "0"
arch/arm/boot/dts/imx7d-cl-som-imx7.dtb: Warning (graph_port): /soc/funnel at 30083000/ports/port at 2: graph node unit address error, expected "0"
arch/arm/boot/dts/imx7d-cl-som-imx7.dtb: Warning (graph_port): /soc/etf at 30084000/ports/port at 1: graph node unit address error, expected "0"

Signed-off-by: Fabio Estevam <fabio.estevam at nxp.com>
---
Hi Rob,

Is this the correct way to fix these warnings?

 arch/arm/boot/dts/imx7s.dtsi | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/arch/arm/boot/dts/imx7s.dtsi b/arch/arm/boot/dts/imx7s.dtsi
index 7d33993..55b6241 100644
--- a/arch/arm/boot/dts/imx7s.dtsi
+++ b/arch/arm/boot/dts/imx7s.dtsi
@@ -126,7 +126,7 @@
 
 			/* replicator input port */
 			port at 2 {
-				reg = <0>;
+				reg = <2>;
 				replicator_in_port0: endpoint {
 					slave-mode;
 					remote-endpoint = <&etf_out_port>;
@@ -183,7 +183,7 @@
 
 				/* funnel output port */
 				port at 2 {
-					reg = <0>;
+					reg = <2>;
 					ca_funnel_out_port0: endpoint {
 						remote-endpoint = <&hugo_funnel_in_port0>;
 					};
@@ -234,7 +234,7 @@
 				};
 
 				port at 2 {
-					reg = <0>;
+					reg = <2>;
 					hugo_funnel_out_port0: endpoint {
 						remote-endpoint = <&etf_in_port>;
 					};
@@ -263,7 +263,7 @@
 				};
 
 				port at 1 {
-					reg = <0>;
+					reg = <1>;
 					etf_out_port: endpoint {
 						remote-endpoint = <&replicator_in_port0>;
 					};
-- 
2.7.4