[RFC PATCH] driver core: make deferring probe forever optional

[Michal Simek]

On 14.5.2018 09:37, Alexander Graf wrote:
> 
> On 05/14/2018 12:01 AM, Linus Walleij wrote:
>> On Wed, May 9, 2018 at 11:44 AM, Alexander Graf <agraf at suse.de> wrote:
>>> On 05/07/2018 08:31 PM, Bjorn Andersson wrote:
>>>> Can you please name platform that has enough support for Alexander to
>>>> care about backwards and forwards compatibility but lacks a pinctrl
>>>> driver.
>>> ZynqMP is one example that immediately comes to my mind. I'm sure
>>> there are
>>> others too.
>> Why isn't that using drivers/pinctrl/pinctrl-zynq.c?
>>
>> How is it so very different from (old) Zynq as it is already using
>> the same GPIO driver?
> 
> That one is very simple: ZynqMP is usually an AMP system where Linux
> doesn't have full knowledge of the overall system. IIUC they have a tiny
> microblaze (PMU) that does the actual full system configuration for
> peripherals that may interfere with each other. This architecture also
> allows for safety critical code to run alongside a (less safe) Linux
> system.

Linux is running in non secure world that's why Linux can't have full
system visibility and Linux should ask firmware. It doesn't matter if
firmware is running on specific unit or just secure SW in EL3/EL1-S, EL0-S.
You can also configure ZynqMP to protect these address ranges not to be
accessible from NS sw.
If you don't care about security you can use normal read/write accesses
at least for gpio case. Pinctrl/clk will be driven via firmware interface.

On Zynq we have never finished running Linux in NS and having firmware
to handle it that's why only read/write is used there.

Thanks,
Michal