Allwinner A64: Issue on external rtc clock to wifi chip

[Maxime Ripard]

On Mon, May 14, 2018 at 02:34:22PM +0530, Jagan Teki wrote:
> On Mon, May 14, 2018 at 1:57 PM, Maxime Ripard
> <maxime.ripard at bootlin.com> wrote:
> > On Mon, May 14, 2018 at 01:34:56PM +0530, Jagan Teki wrote:
> >> On Mon, May 14, 2018 at 1:27 PM, Maxime Ripard
> >> <maxime.ripard at bootlin.com> wrote:
> >> > Hi,
> >> >
> >> > On Mon, May 14, 2018 at 12:37:49PM +0530, Jagan Teki wrote:
> >> >> Hi Maxime and All,
> >> >>
> >> >> We are trying to bring-up AP6330 Wifi chip for A64 board. We noticed
> >> >> to have an external rtc clock has driven from wifi chip.
> >> >>
> >> >> So the devicetree is configured according to this as below.
> >> >>
> >> >> / {
> >> >>         wifi_pwrseq: wifi-pwrseq {
> >> >>                 compatible = "mmc-pwrseq-simple";
> >> >>                 clocks = <&rtc 1>;
> >> >>                 clock-names = "ext_clock";
> >> >>                 reset-gpios = <&r_pio 0 2 GPIO_ACTIVE_LOW>; /* PL2 */
> >> >>                 post-power-on-delay-ms = <400>;
> >> >>         };
> >> >> };
> >> >>
> >> >> &rtc {
> >> >>         clock-output-names = "rtc-osc32k", "rtc-osc32k-out";
> >> >>         clocks = <&osc32k>;
> >> >>         #clock-cells = <1>;
> >> >> };
> >> >>
> >> >> &mmc1 {
> >> >>         pinctrl-names = "default";
> >> >>         pinctrl-0 = <&mmc1_pins>;
> >> >>         vmmc-supply = <&reg_dcdc1>;
> >> >>         vqmmc-supply = <&reg_eldo1>;
> >> >>         mmc-pwrseq = <&wifi_pwrseq>;
> >> >>         bus-width = <4>;
> >> >>         non-removable;
> >> >>         status = "okay";
> >> >>
> >> >>         brcmf: wifi at 1 {
> >> >>                 reg = <1>;
> >> >>                 compatible = "brcm,bcm4329-fmac";
> >> >>                 interrupt-parent = <&r_pio>;
> >> >>                 interrupts = <0 3 IRQ_TYPE_LEVEL_LOW>;  /* WL-WAKE-AP: PL3 */
> >> >>                 interrupt-names = "host-wake";
> >> >>         };
> >> >> };
> >> >>
> >> >> And observed rtc-osc32k-out clock is never enabled[1] and the value of
> >> >> LOSC_OUT_GATING is 0x0 which eventually not enabling
> >> >> LOSC_OUT_GATING_EN
> >> >>
> >> >> Pls. let us know if we miss anything here?
> >> >>
> >> >> [1] https://paste.ubuntu.com/p/X2By4q8kD2/
> >> >
> >> > Could you paste your config and the logs from a boot to?
> >>
> >> .config
> >> https://paste.ubuntu.com/p/w9w2KB7RFc/
> >>
> >> dmesg
> >> https://paste.ubuntu.com/p/mrZGk5bWRR/
> >
> > This is kind of weird. Have you tested with a 4.17 kernel? We have
> > runtime_pm changes lined up in next, so that might be a regression
> > there, even though we tested it with Quentin at some point.
> 
> This is 4.17-rc4 do you want to try it on 4.16 ?

No, this is next-20180503. Please try with 4.17-rc4

Maxime

-- 
Maxime Ripard, Bootlin (formerly Free Electrons)
Embedded Linux and Kernel engineering
https://bootlin.com
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 833 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20180514/4a2bdde5/attachment-0001.sig>