[PATCH] mtd: nxp-spifi: decrement flash_np refcnt on error paths

Boris Brezillon boris.brezillon at bootlin.com
Wed May 9 02:42:50 PDT 2018


On Tue,  8 May 2018 23:47:36 +0300
Alexey Khoroshilov <khoroshilov at ispras.ru> wrote:

> nxp_spifi_probe() increments refcnt of SPI flash device node by
> of_get_next_available_child() and then it passes the node
> to mtd device in nxp_spifi_setup_flash().
> But if a failure happens before mtd_device_register() succeed,
> the refcnt is left undecremented.

Why not doing that in the error path of the probe function? Also, you
probably want to call of_node_put() in the ->remove() function.

> 
> Found by Linux Driver Verification project (linuxtesting.org).
> 
> Signed-off-by: Alexey Khoroshilov <khoroshilov at ispras.ru>
> ---
>  drivers/mtd/spi-nor/nxp-spifi.c | 16 +++++++++++-----
>  1 file changed, 11 insertions(+), 5 deletions(-)
> 
> diff --git a/drivers/mtd/spi-nor/nxp-spifi.c b/drivers/mtd/spi-nor/nxp-spifi.c
> index 15374216d4d9..8919e31f2ab8 100644
> --- a/drivers/mtd/spi-nor/nxp-spifi.c
> +++ b/drivers/mtd/spi-nor/nxp-spifi.c
> @@ -294,7 +294,8 @@ static int nxp_spifi_setup_flash(struct nxp_spifi *spifi,
>  			break;
>  		default:
>  			dev_err(spifi->dev, "unsupported rx-bus-width\n");
> -			return -EINVAL;
> +			ret = -EINVAL;
> +			goto err_node_put;
>  		}
>  	}
>  
> @@ -328,7 +329,8 @@ static int nxp_spifi_setup_flash(struct nxp_spifi *spifi,
>  		break;
>  	default:
>  		dev_err(spifi->dev, "only mode 0 and 3 supported\n");
> -		return -EINVAL;
> +		ret = -EINVAL;
> +		goto err_node_put;
>  	}
>  
>  	writel(ctrl, spifi->io_base + SPIFI_CTRL);
> @@ -356,22 +358,26 @@ static int nxp_spifi_setup_flash(struct nxp_spifi *spifi,
>  	ret = spi_nor_scan(&spifi->nor, NULL, &hwcaps);
>  	if (ret) {
>  		dev_err(spifi->dev, "device scan failed\n");
> -		return ret;
> +		goto err_node_put;
>  	}
>  
>  	ret = nxp_spifi_setup_memory_cmd(spifi);
>  	if (ret) {
>  		dev_err(spifi->dev, "memory command setup failed\n");
> -		return ret;
> +		goto err_node_put;
>  	}
>  
>  	ret = mtd_device_register(&spifi->nor.mtd, NULL, 0);
>  	if (ret) {
>  		dev_err(spifi->dev, "mtd device parse failed\n");
> -		return ret;
> +		goto err_node_put;
>  	}
>  
>  	return 0;
> +
> +err_node_put:
> +	of_node_put(np);
> +	return ret;
>  }
>  
>  static int nxp_spifi_probe(struct platform_device *pdev)




More information about the linux-arm-kernel mailing list