[PATCH v3 0/3] arm64: dts: renesas: salvator-x(s)/ulcb: Add PMIC DDR Backup Power config

[Simon Horman]

On Thu, May 03, 2018 at 02:30:48PM +0200, Geert Uytterhoeven wrote:
> 	Hi Simon, Magnus,
> 
> The ROHM BD9571MWV PMIC on the Renesas Salvator-X(S) and ULCB
> development boards supports DDR Backup Power, which means that the DDR
> power rails can be kept powered while the main SoC is powered down.
> 
> For this to function correctly, the DDR Backup Power configuration
> must be described in DT, which is the topic of this series:
>   - The first patch adds the missing device node for the BD9571 PMIC on
>     the ULCB boards,
>   - The last two patches add DDR Backup Mode configuration for
>     Salvator-X(S) and ULCB.
> 
> Changes compared to v3:
>   - Use a hex value for the bit mask.
> 
> Changes compared to v2:
>   - Add support for ULCB,
>   - Add "rohm,rstbmode-level" for Salvator-X(S).
> 
> The relevant DT binding updates have been accepted in
> regulator/for-next, as well as driver support for DDR Backup Mode on
> systems with momentary power switches ("rohm,rstbmode-pulse"), like
> ULCB.  Combined with this series, the PMIC on ULCB will be configured
> automatically during system suspend.
> 
> Note that driver support for systems with toggle power swiches
> ("rohm,rstbmode-level"), like Salvator-X(S), is still under review
> (https://lkml.org/lkml/2018/3/14/324).  But as DT describes hardware,
> not software limitations, this series is safe to apply.
> 
> This has been tested on M3ULCB (thanks Jacopo!), and on Salvator-X(S).
> All support has been part of renesas-drivers since a few releases.
> 
> Thanks for applying!

Thanks, applied.