[PATCH 3/4] Documentation: bindings: add phy_config for Rockchip USB Type-C PHY

Lin Huang hl at rock-chips.com
Fri May 4 01:08:57 PDT 2018


If want to do training outside DP Firmware, need phy voltage swing
and pre_emphasis value.

Signed-off-by: Lin Huang <hl at rock-chips.com>
---
 Documentation/devicetree/bindings/phy/phy-rockchip-typec.txt | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/Documentation/devicetree/bindings/phy/phy-rockchip-typec.txt b/Documentation/devicetree/bindings/phy/phy-rockchip-typec.txt
index 960da7f..eda26dd 100644
--- a/Documentation/devicetree/bindings/phy/phy-rockchip-typec.txt
+++ b/Documentation/devicetree/bindings/phy/phy-rockchip-typec.txt
@@ -17,7 +17,9 @@ Required properties:
 
 Optional properties:
  - extcon : extcon specifier for the Power Delivery
-
+ - rockchip,phy_config : That's phy voltage swing and pre_emphasis
+			 setting, if want to do dp training outside
+			 dp firmware, need to add these value.
 Required nodes : a sub-node is required for each port the phy provides.
 		 The sub-node name is used to identify dp or usb3 port,
 		 and shall be the following entries:
-- 
2.7.4




More information about the linux-arm-kernel mailing list