[PATCH v5 10/14] dt-bindings: qcom_spmi: Add support for SAW documentation

Ilia Lin ilialin at codeaurora.org
Thu May 3 04:52:31 PDT 2018


Add support for SAW controlled regulators.
The regulators defined as SAW controlled in the device tree
will be controlled through special CPU registers instead of direct
SPMI accesses.
This is required especially for CPU supply regulators to synchronize
with clock scaling and for Automatic Voltage Switching.
Document it.

Signed-off-by: Ilia Lin <ilialin at codeaurora.org>
---
 .../bindings/regulator/qcom,spmi-regulator.txt     | 45 ++++++++++++++++++++++
 1 file changed, 45 insertions(+)

diff --git a/Documentation/devicetree/bindings/regulator/qcom,spmi-regulator.txt b/Documentation/devicetree/bindings/regulator/qcom,spmi-regulator.txt
index 57d2c65..406f2e5 100644
--- a/Documentation/devicetree/bindings/regulator/qcom,spmi-regulator.txt
+++ b/Documentation/devicetree/bindings/regulator/qcom,spmi-regulator.txt
@@ -110,6 +110,11 @@ Qualcomm SPMI Regulators
 	Definition: Reference to regulator supplying the input pin, as
 		    described in the data sheet.
 
+- qcom,saw-reg:
+	Usage: optional
+	Value type: <phandle>
+	Description: Reference to syscon node defining the SAW registers.
+
 
 The regulator node houses sub-nodes for each regulator within the device. Each
 sub-node is identified using the node's name, with valid values listed for each
@@ -201,6 +206,17 @@ see regulator.txt - with additional custom properties described below:
 			2 = 0.55 uA
 			3 = 0.75 uA
 
+- qcom,saw-slave:
+	Usage: optional
+	Value type: <boo>
+	Description: SAW controlled gang slave. Will not be configured.
+
+- qcom,saw-leader:
+	Usage: optional
+	Value type: <boo>
+	Description: SAW controlled gang leader. Will be configured as
+		     SAW regulator.
+
 Example:
 
 	regulators {
@@ -221,3 +237,32 @@ Example:
 
 		....
 	};
+
+Example 2:
+
+	saw3: syscon at 9A10000 {
+		compatible = "syscon";
+		reg = <0x9A10000 0x1000>;
+	};
+
+	...
+
+	spm-regulators {
+		compatible = "qcom,pm8994-regulators";
+		qcom,saw-reg = <&saw3>;
+		s8 {
+			qcom,saw-slave;
+		};
+		s9 {
+			qcom,saw-slave;
+		};
+		s10 {
+			qcom,saw-slave;
+		};
+		pm8994_s11_saw: s11 {
+			qcom,saw-leader;
+			regulator-always-on;
+			regulator-min-microvolt = <900000>;
+			regulator-max-microvolt = <1140000>;
+		};
+	};
-- 
1.9.1




More information about the linux-arm-kernel mailing list