[PATCH v4 07/14] clk: qcom: Add ACD path to CPU clock driver for msm8996
Ilia Lin
ilialin at codeaurora.org
Thu Mar 29 14:26:40 PDT 2018
The PMUX for each duplex allows for selection of ACD clock source.
The DVM (Dynamic Variation Monitor) will flag an error
when a voltage droop event is detected. This flagged error
enables ACD to provide a div-by-2 clock, sourced from the primary PLL.
The duplex will be provided the divided clock
until a pre-programmed delay has expired.
This change configures ACD during the probe and switches
the PMUXes to the ACD clock source.
Signed-off-by: Ilia Lin <ilialin at codeaurora.org>
---
drivers/clk/qcom/clk-cpu-8996.c | 75 +++++++++++++++++++++++++++++++++++------
1 file changed, 65 insertions(+), 10 deletions(-)
diff --git a/drivers/clk/qcom/clk-cpu-8996.c b/drivers/clk/qcom/clk-cpu-8996.c
index 064a3fe..9a43bdf 100644
--- a/drivers/clk/qcom/clk-cpu-8996.c
+++ b/drivers/clk/qcom/clk-cpu-8996.c
@@ -63,9 +63,11 @@
*/
#include <linux/clk.h>
+#include <linux/clk-provider.h>
#include <linux/module.h>
#include <linux/platform_device.h>
#include <linux/regmap.h>
+#include <soc/qcom/kryo-l2-accessors.h>
#include "clk-alpha-pll.h"
#include "clk-regmap.h"
@@ -79,6 +81,11 @@ enum _pmux_input {
};
#define DIV_2_THRESHOLD 600000000
+#define PWRCL_REG_OFFSET 0x0
+#define PERFCL_REG_OFFSET 0x80000
+#define MUX_OFFSET 0x40
+#define ALT_PLL_OFFSET 0x100
+#define SSSCTL_OFFSET 0x160
static const u8 prim_pll_regs[PLL_OFF_MAX_REGS] = {
[PLL_OFF_L_VAL] = 0x04,
@@ -117,7 +124,7 @@ enum _pmux_input {
};
static struct clk_alpha_pll perfcl_pll = {
- .offset = 0x80000,
+ .offset = PERFCL_REG_OFFSET,
.regs = prim_pll_regs,
.flags = SUPPORTS_DYNAMIC_UPDATE | SUPPORTS_FSM_MODE,
.clkr.hw.init = &(struct clk_init_data){
@@ -129,7 +136,7 @@ enum _pmux_input {
};
static struct clk_alpha_pll pwrcl_pll = {
- .offset = 0x0,
+ .offset = PWRCL_REG_OFFSET,
.regs = prim_pll_regs,
.flags = SUPPORTS_DYNAMIC_UPDATE | SUPPORTS_FSM_MODE,
.clkr.hw.init = &(struct clk_init_data){
@@ -159,7 +166,7 @@ enum _pmux_input {
};
static struct clk_alpha_pll perfcl_alt_pll = {
- .offset = 0x80100,
+ .offset = PERFCL_REG_OFFSET + ALT_PLL_OFFSET,
.regs = alt_pll_regs,
.vco_table = alt_pll_vco_modes,
.num_vco = ARRAY_SIZE(alt_pll_vco_modes),
@@ -173,7 +180,7 @@ enum _pmux_input {
};
static struct clk_alpha_pll pwrcl_alt_pll = {
- .offset = 0x100,
+ .offset = PWRCL_REG_OFFSET + ALT_PLL_OFFSET,
.regs = alt_pll_regs,
.vco_table = alt_pll_vco_modes,
.num_vco = ARRAY_SIZE(alt_pll_vco_modes),
@@ -186,6 +193,9 @@ enum _pmux_input {
},
};
+void __iomem *base;
+static void qcom_cpu_clk_msm8996_acd_init(void __iomem *base);
+
/* Mux'es */
struct clk_cpu_8996_mux {
@@ -263,6 +273,7 @@ int cpu_clk_notifier_cb(struct notifier_block *nb, unsigned long event,
switch (event) {
case PRE_RATE_CHANGE:
ret = clk_cpu_8996_mux_set_parent(&cpuclk->clkr.hw, ALT_INDEX);
+ qcom_cpu_clk_msm8996_acd_init(base);
break;
case POST_RATE_CHANGE:
if (cnd->new_rate < DIV_2_THRESHOLD)
@@ -270,7 +281,7 @@ int cpu_clk_notifier_cb(struct notifier_block *nb, unsigned long event,
DIV_2_INDEX);
else
ret = clk_cpu_8996_mux_set_parent(&cpuclk->clkr.hw,
- PLL_INDEX);
+ ACD_INDEX);
break;
default:
ret = 0;
@@ -286,7 +297,7 @@ int cpu_clk_notifier_cb(struct notifier_block *nb, unsigned long event,
};
static struct clk_cpu_8996_mux pwrcl_smux = {
- .reg = 0x40,
+ .reg = PWRCL_REG_OFFSET + MUX_OFFSET,
.shift = 2,
.width = 2,
.clkr.hw.init = &(struct clk_init_data) {
@@ -302,7 +313,7 @@ int cpu_clk_notifier_cb(struct notifier_block *nb, unsigned long event,
};
static struct clk_cpu_8996_mux perfcl_smux = {
- .reg = 0x80040,
+ .reg = PERFCL_REG_OFFSET + MUX_OFFSET,
.shift = 2,
.width = 2,
.clkr.hw.init = &(struct clk_init_data) {
@@ -318,7 +329,7 @@ int cpu_clk_notifier_cb(struct notifier_block *nb, unsigned long event,
};
static struct clk_cpu_8996_mux pwrcl_pmux = {
- .reg = 0x40,
+ .reg = PWRCL_REG_OFFSET + MUX_OFFSET,
.shift = 0,
.width = 2,
.pll = &pwrcl_pll.clkr.hw,
@@ -339,7 +350,7 @@ int cpu_clk_notifier_cb(struct notifier_block *nb, unsigned long event,
};
static struct clk_cpu_8996_mux perfcl_pmux = {
- .reg = 0x80040,
+ .reg = PERFCL_REG_OFFSET + MUX_OFFSET,
.shift = 0,
.width = 2,
.pll = &perfcl_pll.clkr.hw,
@@ -403,6 +414,10 @@ struct clk_regmap *clks[] = {
clk_alpha_pll_configure(&perfcl_alt_pll, regmap, &altpll_config);
clk_alpha_pll_configure(&pwrcl_alt_pll, regmap, &altpll_config);
+ /* Enable alt PLLs */
+ clk_prepare_enable(pwrcl_alt_pll.clkr.hw.clk);
+ clk_prepare_enable(perfcl_alt_pll.clkr.hw.clk);
+
ret = clk_notifier_register(pwrcl_pmux.clkr.hw.clk, &pwrcl_pmux.nb);
if (ret)
return ret;
@@ -412,10 +427,48 @@ struct clk_regmap *clks[] = {
return ret;
}
+#define CPU_AFINITY_MASK 0xFFF
+#define PWRCL_CPU_REG_MASK 0x3
+#define PERFCL_CPU_REG_MASK 0x103
+
+#define L2ACDCR_REG 0x580ULL
+#define L2ACDTD_REG 0x581ULL
+#define L2ACDDVMRC_REG 0x584ULL
+#define L2ACDSSCR_REG 0x589ULL
+
+static DEFINE_SPINLOCK(acd_lock);
+
+static void qcom_cpu_clk_msm8996_acd_init(void __iomem *base)
+{
+ u64 hwid;
+ unsigned long flags;
+
+ spin_lock_irqsave(&acd_lock, flags);
+
+ hwid = read_cpuid_mpidr() & CPU_AFINITY_MASK;
+
+ set_l2_indirect_reg(L2ACDTD_REG, 0x00006A11);
+ set_l2_indirect_reg(L2ACDDVMRC_REG, 0x000E0F0F);
+ set_l2_indirect_reg(L2ACDSSCR_REG, 0x00000601);
+
+ if (PWRCL_CPU_REG_MASK == (hwid | PWRCL_CPU_REG_MASK)) {
+ writel(0xF, base + PWRCL_REG_OFFSET + SSSCTL_OFFSET);
+ wmb();
+ set_l2_indirect_reg(L2ACDCR_REG, 0x002C5FFD);
+ }
+
+ if (PERFCL_CPU_REG_MASK == (hwid | PERFCL_CPU_REG_MASK)) {
+ set_l2_indirect_reg(L2ACDCR_REG, 0x002C5FFD);
+ writel(0xF, base + PERFCL_REG_OFFSET + SSSCTL_OFFSET);
+ wmb();
+ }
+
+ spin_unlock_irqrestore(&acd_lock, flags);
+}
+
static int qcom_cpu_clk_msm8996_driver_probe(struct platform_device *pdev)
{
int ret;
- void __iomem *base;
struct resource *res;
struct regmap *regmap;
struct clk_hw_onecell_data *data;
@@ -439,6 +492,8 @@ static int qcom_cpu_clk_msm8996_driver_probe(struct platform_device *pdev)
if (ret)
return ret;
+ qcom_cpu_clk_msm8996_acd_init(base);
+
data->hws[0] = &pwrcl_pmux.clkr.hw;
data->hws[1] = &perfcl_pmux.clkr.hw;
data->num = 2;
--
1.9.1
More information about the linux-arm-kernel
mailing list