[net-next PATCH v2 03/10] net: netcp: ethss: make call to gbe_sgmii_config() conditional

[Murali Karicheri]

On 03/27/2018 01:18 PM, Andrew Lunn wrote:
> On Tue, Mar 27, 2018 at 12:31:42PM -0400, Murali Karicheri wrote:
>> As a preparatory patch to add support for 2u cpsw hardware found on
>> K2G SoC, make call to gbe_sgmii_config() conditional. This is required
>> since 2u uses RGMII interface instead of SGMII and to allow for driver
>> re-use.
>>
>> Signed-off-by: Murali Karicheri <m-karicheri2 at ti.com>
>> ---
>>  drivers/net/ethernet/ti/netcp_ethss.c | 7 +++++--
>>  1 file changed, 5 insertions(+), 2 deletions(-)
>>
>> diff --git a/drivers/net/ethernet/ti/netcp_ethss.c b/drivers/net/ethernet/ti/netcp_ethss.c
>> index 56dbc0b..1dea891 100644
>> --- a/drivers/net/ethernet/ti/netcp_ethss.c
>> +++ b/drivers/net/ethernet/ti/netcp_ethss.c
>> @@ -2271,7 +2271,8 @@ static int gbe_slave_open(struct gbe_intf *gbe_intf)
>>  
>>  	void (*hndlr)(struct net_device *) = gbe_adjust_link;
>>  
>> -	gbe_sgmii_config(priv, slave);
>> +	if ((priv->ss_version == GBE_SS_VERSION_14) || IS_SS_ID_NU(priv))
>> +		gbe_sgmii_config(priv, slave);
> 
> Or maybe:
> 
>    if (slave->phy_node == PHY_INTERFACE_MODE_SGMII)
>    	gbe_sgmii_config(priv, slave);
> 
> 	Andrew
> Actually, on specific cpsw hardware, driver supports specific interface. Driver also
uses link-interface DT property to configure this and link-interface can be without phy
as well. So essentially the above code looks good IMO.

I need to change this as 

if (IS_SS_ID_VER_14(priv) || IS_SS_ID_NU(priv))
    gbe_sgmii_config(priv, slave);

Based on the link-interface, driver selects the phy mode and pass it to of_phy_connect().

I will update the above in v3.
-- 
Murali Karicheri
Linux Kernel, Keystone